Operators Manual Installation Instruction

FCC ID: ACLAP4W01

Operational Description

Download: PDF
FCCID_77014

Exhibit 748 ACLAPAWO1 INSTALLATION & GROUNDING INSTRUCTIONS Examine Your Oven Wiring Requirements Unpack oven, remove all packing materia! and examine the oven 1. The oven must be on a SEPARATE CIRCUIT. No other for any damage such as dents, broken doorlatches or cracks in appliance should share the cirouit with the microwave oven. the door. Notify dealer immediately if oven is damaged. If it does, the branch cirouit fuse may blow, the circult breaker DO NOT install if oven is damaged. may trip, or the food may cook slower than the times recommended in this manual. Placement of Oven 2. The VOLTAGE used must be the same as specified on this . Oven must be placed on a flat, stable surface. For proper microwave oven (120 V, 60 Hz). Using a higher voltage is operation, the oven must have sufficient air flow. Allow 3—inches dangerous and may result in a fire or otherincident causing (7.6 em) of space on both sides of the oven and 1—inch (2.5 oven damage. Using a lower voltage will cause slow cooking. cm) of space on top of oven. Panasonic is NOT responsible for damage resulting from the a. DO NOT block air vents. If they are blocked during operation, use of the oven with other than specified voltage. the oven may overheat. If the oven overheats, a thermal 3. The oven must beplugged into at least a 20 AMP, 120 VOLT, safety device will turn the oven off. The oven will remain 60 Hz GROUNDED OUTLET. Where a standard two—prong inoperable until it has cooled. outlet is encountered, it is the personal responsibilty and b. DO NOT place oven near a hot, damp surface such as a gas obligation of the consumerto have it or electric range. replaced with a properly grounded ©. DO NOT operate oven when room humidity is too high. three—prong outlet. @ 2. This oven was manufactured for household use only. TV / Radio Interference Grounding Instructions 1. Operation of the microwave oven may cause interference to yourradio, TV or similar equipment. This appliance must be grounded. in the event of an electrical short circult, grounding reduces the risk of electric shock by 2. When there is interference, it may be reduced or eliminated by providing an escape wire for the electric current. This appliance is taking thefollowing measures: equipped with a cord having a grounding wire with a grounding a. Clean door and sealing surfaces of the oven. (See Care plug. The plug must be plugged into an outlet that is properly of Your Microwave Oven) installed and grounded. b. Place the radio, TV, etc. away from the microwaveoven as WARNING—Improper use of the grounding plug can result in faras possible. — ¢. Use a properly installed antenna to obtain strongersignal a risk of electric shock. reception. Consult a qualfied electrician or service personif the grounding instructions are not completely understood or if doubt exists as to whetherthe appliance is properly grounded. If it is necessary to Glass Tray use an extension cord, use only a three wire extension cord that 1. DO NOT operate the oven without Roller Ring and Glass Tray has a three blade grounding plug, and a three slot receptacle that in place. will accept the plug on the appliance. The marked rating of the 2. DO NOT operate the oven without the Glass Tray fully engaged extension cord should be equal to or greater than the electrical on the drive hub. Improper cooking or damage to the oven rating of the appliance. could result. Verify that the Glass Tray is properly engaged and rotating by observing its rotation when you press Start. Power Supply 3. Only use Glass Trayspecifically designed for this oven. Do not 1. A short power—supply cord is provided to reduce the risks substitute any other glass tray. resulting from becoming entangled in or tripping over a longer 4. If Glass Tray is hot, allow to cool before cleaning or placing in cord. water. 2. Longer cord sets or extension cords are available and may be 5. DO NOT cook directly on Glass Tray. Always place food in a used if care is exercised in their use. microwave—safe dish, or on a rackset in a microwave—safe dish. 3. If a long cord or extension cord is used, (a) the marked 6. If food or utensil on Glass Tray touches oven walls, causing the electrical rating of the cord set or extension cord should be at tray to stop moving, the tray will automatically rotate in opposite least as great as the electrical rating of the appliance, (b) the direction. This is normal. extension cord must be a grounding—type3—wire cord, and 7. Glass Tray can turn in either direction. (c) the longer cord should be arranged so that it will not drape over the counter top or tabletop where it can be pulled on by Roller Ring children or tripped over accidentally. 1. Roller Ring and oven floor should be cleaned frequently to prevent excessive nolse. 2. Roller Ring must always be used for cooking along with Glass Tray. 3. Always replace Roller Ring and Glass Tray in their proper positions. @3


Document Created: 1999-12-17 15:00:24
Document Modified: 1999-12-17 15:00:24
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC