User_manual

FCC ID: 2AUMJEV-07B-LTE

Users Manual

Download: PDF
FCCID_4457926

01 02 03 04 Personal Getting to know your device Charging Base Put the SIM card Charging your device Mobile There are two ways to charge your device. Front Side Back Front Back Bottom The SIM card is not included in the package. A Nano SIM card is available from the user's local operator. Alarm Device Lanyard hole Cellular signal indicator- Green Loudspeaker Charging contacts 4.2/ Charging by charging base Quick positioning indicator- Blue Call button Place the device on the charging base Start Connect the USB cable from charging base to the SOS button Silent mode AC adaptor. button Screw holes Guide The charging base light will glow when charging and turn Unscrew the back cover and remove the cover. solid when fully charged. Insert the SIM card and make sure it’s activated with 4.1/Charging by magnetic USB cable For the first time use, please fully charge the battery TIP for around 2~3 hours credits. Ｃｅｌｌｕｌａｒ ＧＰＳ／Ｇｌｏｎａｓｓ ＷＩＦＩ ＢＬＥ When placing the magnetic USB cable on the device charging contacts make sure it is posi- The charging base is equipped with a 2000mAh back Call 1 button Voice on/off Put the cover back and tighten the screws. TIP up battery, which can charge the device when the tioned correctly. button electricity is off at home or when traveling. Before installing the SIM card, check if Microphone Charging contacts SOS button Loudspeaker USB cable TIP the SIM card has a PIN code or not, if The power indicator (red light) should blink when TIP When the battery level falls below 20% it will send a Power indicator-Red charging and remain solid when fully charged. low battery warning message to people on the yes, please use a cell-phone to remove contact list via text message or APP. the card's PIN code. FCC Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, 01 05 06 07 08 09 10 11 Specification: pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generats, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is Switching on and off device What do the lights mean? Activating an SOS Alarm Between each call, it will have 10 seconds delay, Getting a GPS fix Fall down alarm Making a Phone Call Silent mode button Dimension: 61mm*44mm*16mm no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by during this time, user can stop call sequence or prevent turning the equipment off and on, the user is encouraged to try to correct the interference by Cellular signal indicator--Green Weight: 40g one or more of the following measures: a possible false alarm by pressing the SOS button. To get an initial fix for the GPS features, use outdoors Device detects a fall and it will automatically send an To make a call, press side call button for 3 seconds Light shows a single flash Light shows a double flash Hold and press this button for 2 seconds to turn off o Reorient or relocate the receiving antenna. Green The receiver of the call can also stop call sequence by or near a window so the device can get a fix on the alarm to emergency contacts. and you will hear a beep, and then it will dial the Battery: Rechargeable, 3.7V, 800mAh o Increase the separation between the equipment and receiver. voice warnings, press 2 seconds again to turn on voice 1sec. rapidly every 3 seconds rapidly every 3 seconds pressing 1 on their mobile phone during two way satellites. This could take few minutes according to second number. o Connect the equipment into an outlet on a circuit different from that to which the The device has a stable The device is registered to warnings. receiver is connected. Means cellular signal the cellular network 3-4sec. talking. your environment. Charging voltage: 5V DC o Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer （Press for 3-4 seconds） Use the side buttons +/- to adjust the sound volume Waterproof: IP67 could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two （All the LEDs will flash rapidly） Positioning indicator--Blue during a call. conditions: (1) This device may not cause harmful interference, and (2) this device must accept BEEP! 4 locating technologies: GPS, BLE, WIFI, LBS any interference received, including interference that may cause undesired operation. To turn on the device: press the SOS button for 1 Blue Light shows a single flash rapidly every 3 seconds second, all the LEDs will flash rapidly. The device can also be turned on automatically by charging via magnetic USB cable or put it into the docking Means The device has no latest location fix When you need help, press the SOS button for 3-4 TIP Please remember to program emergency contact numbers. It is not mandatory for GPS 3sec. 2sec. Cautions: SAR Specific Absorption Rate (SAR) information: This Personal Mobile Alarm System meets the government's requirements for exposure to radio seconds till you hear a voice prompt of activating an Please comply with the instructions to extend the unit life: waves. The guidelines are based on standards that were developed by independent scientific station. Blue Light shows a double flash Light Off SOS alarm. This starts the sequence of “help me!” all ten authorized numbers to be set, organizations through periodic and thorough evaluation of scientific studies. The standards rapidly every 3 seconds text message send to your emergency contact num- however a minimum of one must always Due to the daily life activities (like some sports, sit Don’t use & store the unit in dusty places. include a substantial safety margin designed to assure the safety of all persons regardless of age Means The device has latest The device is not fixing the back on a coach, etc), device may detect a fall incor- Press and hold button 3 seconds, and in the same or health. FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is 1.6 W/ location fix latest location bers followed by the outgoing calls. be set. kg averaged over one gram of tissue. Device types: Personal Mobile Alarm System (FCC ID: rectly, this situation may cause false alarm. However, time press CALL2 button on charging base, they will Don’t put the unit in overheated or over cooled places. To end the call, press the SOS button. 22AUMJEV-07B-LTE) has also been tested against this SAR limit. This device was tested for users can manually cancel the fall alert by pressing pair to each other via bluetooth. typical body-worn operations with the back of the product kept 0mm from the body. To 3sec. Power indicator--Red SOS button during its beeping. SOS Clean the unit with a piece of dry cloth. Don’t clean in chemicals, detergent. maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0mm separation distance between the user's body and the back of the product. Red shows a double flash If the device fails to connect to the first number, it will Please be patient during the call sequence. In the same time The use of accessories that do not satisfy these requirements may not comply with FCC RF Red Red ON (solid) rapidly every 3 seconds call the second number after delay of 10 seconds. In TIP There can be short delays as the alarm Very Important: Because it still has few Don’t disassemble or refit the unit. exposure requirements, and should be avoided. State Device has been fully charged BLE connected case the second number fails to be connected as calls phones who maybe out of range or TIP chances for the non-detected falling Using other batteries will cause unwanted situation. well, the system will connect to the third number etc. delivered to people’s voicemail. down, we still strongly recommend user to press SOS button when it has emergency 3sec. To turn off the device: press and hold the side button and SOS button together for 3 seconds until the Red Red Blinking Quickly Red Off or blinking slowly 3sec. Warning: Keep the IMEI and SIM in confidential, or situation. your privacy may expose. LEDs turn off. Battery power is State The device is charging lower than 20%


Document Created: 2019-09-23 16:43:56
Document Modified: 2019-09-23 16:43:56
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC