User Manual

FCC ID: 2ATWD-040103

Users Manual

Download: PDF
FCCID_4463935

79.3 59.1 22.3 36.8g±0.5g

一 IMPORTANT:Before operating or maintaining this unit,please read these instructions carefully paying extra attention to the safety warnings and precautions.Use this unit correctly and with care.Failure to do so may cause damage and/or personal injury and will invalidate the warranty. D Loosening the tire fl Dismounting the tire Remove the valve cap and core and deflate the tire. Clamp the tire onto thetire changer,and adjust the Use the bead loosener to unseat the tire bead. valve at 1 o'clock relative to the tire separatior:Lbead. Insert the tire tool and lift the tire bead onto th, mounting head to dismount the bead. .A CAUTION: The bead loosener must ' ' be facing the valve. A CAUTION: This starting position must be observed during the whole dismounting process. �Dismounting With a screwdriver remove the fastening screw and sensor m Mounting sensor and valve Slide the valve stem through the valve hole of the rim. from the valve stem.Then loosen the nut and remove the Tighten the screw-nut with 4.0 Nm with the help of the valve. positioning pin.Assemble the sensor and valve stem together by screw.Hold the sensor body against the rim and tighten the screw. Step.1 Step.2 �Mounting the tire Place the tire on the rim,making sure that the valve ° faces the separation head at an angle of 180 . Step.3 Step.4 Mount the tire over the rim.

FCC Requirement changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Manufacturer information: Zhejiang PDW Industrial Co., Ltd. Quanxi Industrial Park, Wuyi County, Jinhua City, Zhejiang, P.R.China 321200 Importer information: City Pro car d.o.o. Surcinska 5b, Belgrade, Serbia


Document Created: 2019-09-20 18:08:05
Document Modified: 2019-09-20 18:08:05
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC