user_manual

FCC ID: 2ATD2-WS1002

Users Manual

Download: PDF
FCCID_4312776

Introduction Instruction: Different application This product is a smart wireless charger with simple 1. Choose an area to set up in car. and decent design, which is compatible with smart FCC Statement phone or device for QI standard. It also can support Changes or modifications not expressly fast charging of iPhone or Samsung. It is convenient and fast. You can approved by the party responsible for co enjoy a free charging experience mpliance could void the user's authority t Appearance and Overview o operate the equipment. This equipment has been tested and found Charging area to comply with the limits for a Class B digital Input interface: 5V/2A, 9V/1.8A Non-skid rubber device, pursuant to Part 15 of the FCC Rules. Output: 5V/1A, 9V/1.8A These limits are designed to provide reasonable protection against harmful interference in a MicroUSB Tear off the protective film of 3 Connect the wireless charging residential installation. This equipment generates 3M on the bottom surface and device to the power supply of input interface uses and can radiate radio frequency energy and, stick to the selected position the car via USB cable, and if not installed and used in accordance with the LED Normal charge: slow flash (clean and keep dry before to make it electrified (LED will Parts List Fast charge: long bright shine, indicating successful instructions, may cause harmful interference to uching) Press for a few seconds FOD: fast flash Wireless charger X1 radio communications. However, there is no g to make it firm and sticky. power supply) 4 Place the device with wireless USB cable X1 uarantee that interference will not occur in a part icular installation. If this equipment does cause ha charging receiving device on X mark locating card X1 rmful interference to radio or television reception, the charger, as shown in the Manual X1 picture which can be determined by turning the equip Blade clip ment off and on, the user is encouraged to try to correct the interference by one or more of Pedestal Attention: the following measures: Pedestal is detachable. For charging efficiency, the thickness -- Reorient or relocate the receiving antenna. It can stick on platform 3M double-sided adhesive of phone's case is suggested less than 2mm, -- Increase the separation between the equip or clamp on AC vent. and over 6mm may lead to slow charging or failure of charging ment and receiver. Do not use metal case. -- Connect the equipment into an outlet on a ci rcuit different from that to which the receiver is connected. Please keep the environment -- Consult the dealer or an experienced radio/ Damped visors allow temperature in 0-45℃ TV technician for help the wireless charger The fast charge mode requires QC 2.0 adapter. to rotate to any Angle 5. T h e X p o sition f i l m i s When the product is used in the car, the phone's c l a m ped b e t w e e n t h e Caution: Any changes or modifications to this device not m o b i le p h o n e w ith w i reless safety protection mechanism may be activated explicitly approved by manufacturer could void your c h a r ging f u n c t i on a n d t he due to the sun exposure at high temperature, so p r o t ection s l e e ve, w h i c h the phone cannot be charged immediately. After authority to operate this equipment. c a n a cc u r a t e l y a nd a utomatical l y the temperature is lowered in the car room, the l o c a te c h a r g i n g product can return to normal use Please keep the charger and receiver away from water and other liquid. If cleaning the charger, please make sure the power is disconnected.


Document Created: 2019-06-11 06:47:40
Document Modified: 2019-06-11 06:47:40
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC