User Manual

FCC ID: 2ASQ9CL800-01

Users Manual

Download: PDF
FCCID_4420120

HEART RATE MONITOR CHEST STRAP USER MANUAL CL800 1

Thank you for using this product as your sports fitness product of choice. The product is a sensor type heart rate monitor that will track your real-time heart rate and send heart rate data to the Smart phone. IMPORTANT This product is for sport purposes only and it is not meant to replace any medical advice. This manual contains important safety and care information, and provides step by step instructions for using this product. Read it thoroughly, and keep the manual in a safe place in case you need to refer to it later. 2

DEVICE OVERVIEW: b. Back View A. Heart rate Transmitter a. Front View 1 2 1. Battery Door 2. Left & Right wearing directions 3

B. Heat rate chest strap 3. Electrodes 4. Fastening buttons 4

GETTING STARTED A. Unpacking the product In this box, you will find: B. To wear chest strap a. Heart rate transmitter a. Wet the conductive pads b. Adjustable elastic Strap on the rear of the chest Strap c. CR2032 battery – already installed with a few drops of water, d. User manual Saliva or conductive gel to ensure solid contact. 5

b. Strap the heart rate chest belt across your chest. To ensure an accurate heart rate signal, adjust the strap 6

until the belt fits snugly below your (chest) pectoral muscles. c. Attach the transmitter to the strap, marked ‘L’ towards left. WARNING Inaccurate heart rate data will be detected if the device is worn in wrong directions. C. To run software on smart phone, receive the heart rate data. 7

WARNING a.Cleaning of transmitter and strap in a washing machine or dryer is strongly prohibited. b.Before hand washing the device, detach the transmitter of Heart Rate Monitor where electrodes are located, This part is not washable. c.While washing the straps, make sure water is no higher than 30°C. d.Ironing, bleaching or heating is prohibited. 8

BATTERIES The transmitter use CR2032 3V battery. The battery already installed. The battery typically last one year . A. Using a coin, twist the battery door counter clockwise until it clicks out of place. B. Remove the old battery and insert the new battery with the +side upwards. C. Replace the battery door by twisting it clockwise until it is firmly in place. 9

IMPORTANT 1. Non-rechargeable and rechargeable batteries must be disposed of properly. For this purpose, special containers are provided for battery disposal at communal collection centers. 2. Batteries are extremely dangerous when swallowed! Therefore, keep batteries and small articles away from children. 3. The batteries supplied must not be recharged, reactivated by any other means, dismantled, put into fire or short-circuited. 10

Disclaimer • The information contained in this manual just for reference. The product described above may be subject to alteration owing to the manufacturer's continuing research and development plans, without making an announcement in advance. • We shall not bare any legal responsibility for any direct or indirect, accidental or special damages, losses and expenses arising from or in connection with this manual or the contained product. 11

CE and FCC statement Hereby, Chileaf, declares that heart rate monitor, Chest, strap(CL800) is in compliance with the essential requirements and other relevant provisions of Directive RED 2014/53/EU. A copy of the signed and dated Declaration of Conformity is available. Notices This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device must not cause harmful interference, and (2) this device must not accept any interference received, including interference that may cause undesired operation. WARNING: Changes or Modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and 12

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ·Reorient or relocate the receiving antenna. ·Increase the separation between the equipment and receiver. ·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ·Consult the dealer or an experienced radio/TV technician for help. This device meets the FCC requirements for RF exposure in public or uncontrolled environments. Waste electrical products should not be disposed of with household waste. 13

Version: V1.1


Document Created: 2019-08-29 19:46:25
Document Modified: 2019-08-29 19:46:25
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC