User Manual

FCC ID: 2ASJM-03C05-A19-01

Users Manual

Download: PDF
FCCID_4374954

RGB+CCT Bulb User Guide 1. Install the smart bulb into a power OFF light socket. 2. Download the Energetic Lighting App from the APP Store or Google Play. Create an account and enter into the APP. 3. Turn on the WIFI on the phone. Tap “+” in the top-right corner of the app and then select “Light”. 4. Screw on your light bulb and wait for 10 seconds, then flip the light switch OFF and ON for 3 times (OFF-ON-OFF-ON-OFF-ON), pausing for one second in between. If successfully, the light will flash rapidly (flashing 2 times per second). 5. Tap “The light is flashing rapidly”, choose WIFI, enter password and tap “confirm”. And wait until it is added successfully.. 6. You can turn on or off the bulb, and adjust its brightness and CCT using the app. 7. If the bulb is switched off, or preset-WIFI is not available, it cannot be controlled by app. FCC Warning Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. ISEDC RSS warning This device complies with Innovation, Science and Economic Development Canada Compliance licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique ISEDC applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. FCC/ ISEDC Radiation Exposure Statement This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet équipement doit être installé et utilisé avec un minimum de 20cm de distance entre le radiateur et votre corps. Cet émetteur ne doit pas être co-localisés ou fonctionner en conjonction avec une autre antenne ou émetteur.


Document Created: 2019-07-26 14:54:36
Document Modified: 2019-07-26 14:54:36
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC