User Manual

FCC ID: 2AR8EU116HK010137T

Users Manual

Download: PDF

Charging the Mouse Droid:




1. The Micro USB cable connects to the Mouse Droid
2. The USB will connect to your computer or electrical outlet to complete the charge
3. Red light On indicates: Charging
4. Red light Off indicates: Charge is completed

*Approx.
The charge lead time by computer takes up to 6-7 hours (500mA input current)
The charge lead time by electrical outlet (not included) takes up 4-5 hours (lA input current)
The Mouse Droid's battery life can run for approximately 5 hours, if the device is fully
charged
BATTERIES NOT REPLACEABLE


Pairing:
      Remote Control                             Mouse Droid
Red Light

On/Off button




                                                               On/Off switch
  1    Turn on Remote Control
  2    The red light flashing for 1 minute indicates the remote is ready for pairing
  3    Turn on the Mouse Droid
  4    When the Mouse Droid and Remote Control are paired, the red light will stay on
  5    If the Mouse Droid and Remote Control are not paired, the red light will turn off.
       The user can press any button on the Remote Control to pair the devices again
  6    If the Mouse Droid is turned off, the user needs to pair the two devices again


                                                               C&TM Lucasfilm Ltd.


Function:
                    On/Off             2




1—Launch Missiles
                                                           4 (Door Open/ Close)

       Sound




Steering axle                                                               On/Off
adjuster




Missiles Instruction:
FIRE all the missiles before reload. The structure will not allow user to
reload 1st & 2nd level missiles before completing the shooting sequence.
1. Press button 1st time — shooting top bullet x 2
2. Press button 2nd time — shooting mid bulletx 2
3. Press button 3rd time — shooting bottom bullet x 2
4. Mechanical reset


This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
        (1) This device may not cause harmful interference.
        (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.

**This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.



Document Created: 2019-01-11 10:40:06
Document Modified: 2019-01-11 10:40:06

© 2019 FCC.report
This site is not affiliated with or endorsed by the FCC