User manual

FCC ID: 2AR3EFLY9

Users Manual

Download: PDF
FCCID_4335896

USER GUIDE EU DECLARATION OF CONFORMITY CAUTION PRODUCT INFORMATION HOW TO CONNECT Thank you for choosing the Fly 9 Neckband Bluetooth Earphones developed by Linklike To Hereby, Lilai (Shenzhen) Technology Co., Ltd declares that the radio equipment of Linklike Fly Fly 9 Neckband Bluetooth Earphones 1. In off mode, long press the center button for 5 seconds to get the headphone into pairing better use this product, please read the Quick Start Guide carefully before use and properly 9 neckband Bluetooth earphones are in compliance with Directive 2014/53/EU. The full text of Use the Bluetooth Earphone in the environment with the temperature status with an English voice prompt ‘power on’. During the pairing process, the red and manage it. the EU declaration of conformity is available at the following internet ① Ear support blue lights flash by turns. The headphone will automatically shut down if pairing fails between-10℃ and 40℃. address:http://www.linklike-audio.com/ within 5 minutes. ② ABS plastic front and back the cavity 2. Turn on the Bluetooth on your mobile phone, then search the Bluetooth device. PRODUCT SPECIFICATIONS The product shall only be connected to a USB interface of version USB2.0 or ③ Volume up/Next track higher and that the connection to a power USB is prohibited. 3. Choose Bluetooth device named ‘UiiSii BN80 ‘and enter pairing password ‘0000’ to ④ Turn on/Turn off/Answer Bluetooth version 5.0 Speaker size 6mm connect with it. When voice notice “connected” indicate connected successful, The red User Manual /End call/Reject call/Play/Pause and blue lights flashe twice every 4 seconds in connected status. For Battery: Risk of explosion battery is replaced by an incorrect type, dispose of Bluetooth chip QCC3003 Frequency range 20~20000Hz used batteries according to the instructions. ⑤ Volume down/Previous trackNext track Fly 9 Neckband Bluetooth Earphones ⑥ LED (White light /Blue light) Transmission range About 10m Neck line length 300mm L To prevent possible hearing damage, do not listen at high volume levels for long ⑦ The USB connector Charging time About 2.5h Sensitivity 105±3dB periods. ⑧ Battery Music play time/Talk time About 15h Impedance 32Ω ⑨ Neck line Standby time About 480h Battery Capacity Li-Polymer Battery 3.7V/250mAh HOW TO USE HOW TO CHARGE IMPORTANT SAFETY INFORMATION ● Listen Responsibly FCC WARNNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two To avoid hearing impairment, please make sure to turn down the volume of the music conditions: Turn on : In power off mode, press and hold the middle button for 2 seconds, and there will be Using Micro USB cable and plug in the charging port to charge .Low battery (talking time less ● Don't remove or replace the Battery,including sensitive electronic components, including a This equipment has been tested and found to comply with the limits for a Class B digital device, player before connecting the earphones. After putting the earphones into/onto the ears, an English voice prompt of ‘power on’ . The red and blue LEDs will flash for 1 second. than 10 minutes) : there will be a voice prompt ‘battery low’and prompt once per minute ,when battery,and can be damaged or cause injury if dropped, burned, punctured, crushed, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection turn up the volume gradually until to a comfortable listening level. Noise level is measured ● This device may not cause harmful interference battery power lower than 3.1V, it will be shut down automatically. Charging : the white light on disassembled, or if exposed to excessive heat or liquid.Don't use damaged batteries and against harmful interference in a residential installation. This equipment generates uses and Turn off : In any mode,press and hold the middle button for 3 seconds, and there will be an in de- cibels (db). Exposure to 85db or higher noise will lead to gradual hearing impairment. This device must accept any interference received, including interference that may steadily (It can not turn on when charging). electronic components. can radiate radio frequency energy and, if not installed and used in accordance with the ● English voice prompt of ‘power off’ . The red and blue LEDs will flash for 1 second. Please supervise your usage and the hearing impairment is a function of loudness against cause undesired operation. Fully charged : the blue light stays on steadily in LED. instructions, may cause harmful interference to radio communications. However, there is no time. The louder the sound is, the shorter you can be exposed. The softer the sound is, the ● Dispoal and recycling information guarantee that interference will not occur in a particular installation. If this equipment does Volume up/down : Short press once for voice up and down. When sounds become maximum longer you can listen. or minimum, it will have voice prompt. Don't treat the product and battery as a household waste or into a fire. When you decide to cause harmful interference to radio or television reception, which can be determined by dispose of the product and its battery, please follow the local environmental laws to handle turning the equipment off and on, the user is encouraged to try to correct the interference by Answer/End call : Short press middle button once for answering or ending. the battery to avoid an explosion. one or more of the following measures: Reject call : Press and hold the middle button for 2 second in the call ring status . ● Medical device interference ● Reorient or relocate the receiving antenna. Play /Pause: Short press middle button once for playing/pausing music. The product contains components and radios that emit electromagnetic fields and also ● Increase the separation between the equipment and receiver. Previous/Next : In playing music, press and hold volume +/- for 2 second. contains magnets. These electromagnetic fields and magnets may interfere with pac- ● Connect the equipment into an outlet on a circuit different from that to which the emakers,defibrillators, or other medical devices. Maintain a safe distance of separation receiver is connected. Clear paired list : Long press the plus and reduce buttons of sound volume for 5 seconds at the between your medical device and product.Consult your physician and medical device ● Consult the dealer or an experienced radio/TV technician for help same time, the red and blue lights flash for three times simultaneously. manufacturer for information specific to your medical device. Stop using product if you suspect it is interfering with your pacemaker, defibrillator, or any other medical device. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.


Document Created: 2019-06-19 17:05:11
Document Modified: 2019-06-19 17:05:11
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC