User Manual

FCC ID: 2AR2STANX100

Users Manual

Download: PDF
FCCID_4392897











Troubleshooting Before resorting tomaintenanceservice, pleasekindly check by yourself with the following chart. Symptom | Causo(s) | Remedy No Power I® The AC power cord is notconnected to the power|@Please check thatthe AC power cord supply or is notconnected to a powersupply is connected securely. securely. Sound @The volumeis set to the minimum level. (@Turn up the volume. [There is nosound or| the sound is distorted. The buttons on the |@The unit is being Interfered with statlc electricity |@Switch off andunplug the unit. unlt doesn‘t work. otc. Then connect theplug to the power supply and switch iton again. —Symbols placed on the equipment shall be exlained in the user manual. ~ M rar Refers to alternating current (AC) This device is noisesuppressed ess emmn ue gtcprding to the upplica ble EU Refers to direct current directives. This product fulfils the 22222222225 European directives 2014/53/ Refers to class II equipment EU, 2009/125/ EC and 2011/65/EU. 1y fars tto . Refers o ststand—by | CAUTION | Refers to "ON" (power) $ Refers to danger s voltage ATTENTION:Risaue o€ choo £LEcrmoue1e pas ouvni® This lightning flash with arrowhead symbol within an equilateral triengle is intended to alert the user to the presence of non— Insulated *dangerous voltage" within the products enclosure that may be of sufficlent magnitude to constlfute a risk of electric shock. = Waming: To reduce the risk of electric shock, do not remove cover(or back) as there are no user—serviceable parts Inslde. Refer servicing to qualified personnel. = The exclamation point within an equllateral trlangle is Intended to alert the user to the presence of Important operating and maintenance instructions in the literature accompanying the appliance. —10—

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. FCC& IC Radiation Exposure Statement: This equipment complies with FCC and Canada radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Déclaration d’IC sur l’exposition aux radiations: Cet équipement est conforme aux limites d’exposition aux radiations définies par le Canada pour des environnements non contrôlés. Cet émetteur ne doit pas être installé au même endroit ni utilisé avec une autre antenne ou un autre émetteur.



Document Created: 2019-07-19 11:30:00
Document Modified: 2019-07-19 11:30:00
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC