15_ALT-117 UserMan r1

FCC ID: 2AQ7B-IPC130

Users Manual

Download: PDF
FCCID_4048122

487*100mm 105g IP Camera _ M ~p BACopt J Ex( sds serting a Powering On JUST— LISTE s 6 {‘mfi * ho ; C__] ( ‘s ® AC Power Supply a s . Full HD Camera I s Pm When properly inserted. you wil ‘eelthe card will click into place, @(ted) = Powered ON ol Serews & Anchors Reset Tool 1. Micro SD Card Slot 6. Ventilation Holes ©@0@0(blinking) = Wi—Fi Setup Mode ALT—117LIVE— VIDEO 2. LED Indicator Light 7. Speaker 3. Lens 8. Reset Button SUICESTARTGUIDE “t 4. Microphone 9. Micro USB Port "For best resuls, use a Class 4 or higher 5. Light Sensor Micto SD memory card, up to 32 GB Wall Mount 2—Sided Foom Pad PRIEsald l App Setup l edeasals) A @(olue) = W—Fi connected successfully Run the Altec Smart Security System App If the device does not connect in 90 seconds, then reset as per below NOTE: Your IP Camera is supported only on a 2.4GHz W—Fi Nework. 6 Before setup, please make sure your mobile device is C wz connected to a 2.4GHz We—Fi Network. 1908 t iPhone Android Prass to add your camera and Pressto add yourspeakerand For in depth Instruction on using the Altec Smart Security App. follow the app‘s instructions folowthe app‘sinstructions. please refer to the User Manual that can be accessed by selecting ‘Help‘ in the app‘s menu option. & prebmaiqemm; ts To reset, nsert the included reset tool into the reset button. Install Altec Wait untthe LED Indlcator Light tums red Smart Security Wait approximately 15 seconds for the camera to reboot © System App &

FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules. Operationis subject to the following two cenditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected. Consult the dealeror an experienced radioTV technician for help. Warning: Changes or modifications to this 1nit not expressly approved by the part responsible for compliance could void the user‘s authority to operate the equipment FCC Radiation Exposure Statement This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.


Document Created: 2018-10-23 16:52:41
Document Modified: 2018-10-23 16:52:41
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC