user manual_2

FCC ID: 2APXM-RPS-GP12

Users Manual

Download: PDF
FCCID_4010370

Pairing the remote power button with
your Grid Pad
Step 1: Remove the back cover of the remote power button and
insert two AAA batteries (included with your remote).

Step 2: Locate the pairing hole on the Grid Pad, it is just beneath
the headphone socket. Use a paper clip to press and hold until
the pairing LED begins to flash (approx. 5 seconds).

Step 3: Locate the pairing hole on the Remote Power Button
and use the paper clip to press and hold the button (approx. 5
seconds). The LED will flash until it has paired.




                              Pairing hole




                                                          LED
                   Pairing hole

                                             Remote power
                     LED                        button




        Grid Pad


                                                          GP12-RPB-MAN-A


FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.



Document Created: 2018-08-20 16:43:32
Document Modified: 2018-08-20 16:43:32

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC