User Manual

FCC ID: 2APN5IFAN03

Users Manual

Download: PDF
FCCID_4294829

Power on after installing, then you can control the device via the matched 433MHz remote controller. RF remote controller pairing: after powering on, the remote Wi-Fi Fan&Light Controller controller can be paired within 5s; if no operation within 5s, you need to power on again for pairing. iFan03 Light switch Mute switch High speed Medium speed Fan switch Low speed RF clearing Wi-Fi pairing (long press) (long press) 433MHz remote control Input: AC100-240V 50/60Hz 5A Output: Light: AC100-240V 50/60Hz 3A Tungsten lamp: 660W/220V Max LED: 300W/220V Max Fan: AC100-240V 50/60Hz 2A Max Wi-Fi: IEEE 802.11 b/g/n 2.4GHz Note: be sure to install protection devices (fuses or air switches) RF remote control : 433.92MHz before connecting the live wire. Note: This equipment has been tested and found FCC Warning to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits Any Changes or modifications not expressly are designed to provide reasonable protection approved by the party responsible for compliance against harmful interference in a residential could void the user’s authority to operate the installation. This equipment generates uses and can equipment. radiate radio frequency energy and, if not installed This device complies with part 15 of the FCC Rules. and used in accordance with the instructions, may Operation is subject to the following two conditions: cause harmful interference to radio communications. (1) This device may not cause harmful interference, However, there is no guarantee that interference will and (2) this device must accept any interference not occur in a particular installation. If this equipment received, including interference that may cause does cause harmful interference to radio or television undesired operation. reception, which can be determined by turning the equipment off and on, the user is encouraged to try FCC Radiation Exposure Statement: to correct the interference by one or more of the This equipment complies with FCC radiation following measures: exposure limits set forth for an uncontrolled —Reorient or relocate the receiving antenna. environment. This equipment should be installed —Increase the separation between the equipment and operated with minimum distance 20cm between and receiver. the radiator& your body. —Connect the equipment into an outlet on a circuit This transmitter must not be co-located or operating different from that to which the receiver is in conjunction with any other antenna or transmitter. connected. —Consult the dealer or an experienced radio/TV technician for help.


Document Created: 2019-05-27 04:55:18
Document Modified: 2019-05-27 04:55:18
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC