Modular Approval FCC rev.1

FCC ID: 2AN2O-RSW02

Cover Letter(s)

Download: PDF
FCCID_3902292

Beijing Roborock Technology Co., Ltd. Modular Approval Request Letter FCC ID: 2AN2O-RSW02 Data: May 15, 2018 Gentlemen: There’s a WiFi module: BL-R8189ME1 V1.2 that would like to have your authorization as a modular approval. The specific product as below, with its designed features and specified description, meets special requirements for modular approval on FCC Part 15.212 and KDB996369 D01v02 by cross-reference list below. Company Beijing Roborock Technology Co., Ltd. Model Number BL-R8189ME1 V1.2 FCC ID 2AN2O-RSW02 Requirement of FCC Part 15.212 and KDB996369 D01v02 YES / No Note 1. The modular transmitter must have its own RF shielding. No the module doesn’t have its own RF shielding. 2. The modular transmitter must have buffered modulation/data inputs. Yes 3. The modular transmitter must have its own power supply regulation. Yes 4. The modular transmitter must comply with the antenna requirements of Section Yes 15.203 and 15.204(c). 5. The modular transmitter must be tested in a stand-alone configuration, i.e., the No The modular transmitter has been module must not be inside another device during testing. performed the testing with the end- product, therefore has not been performed the testing as a stand-alone and then confirmed the compliance. The module and antenna will be install on the end-product shown in the test set photo. 6. The modular transmitter must be labeled with its own FCC ID number, and, if the No Since there is no space which indicates FCC ID FCC ID is not visible when the module is installed inside another device, then the on this module, FCC ID is indicated in a outside of the device into which the module is installed must also display a label manual and Packing. referring to the enclosed module. 7. The modular transmitter must comply with any specific rule or operating Yes requirements applicable to the transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. 8. The modular transmitter must comply with any applicable RF exposure Yes requirements. For example, FCC Rules in Sections 2.1091, 2.1093 and specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and 15.255(g), require that Unlicensed PCS, UNII and millimeter wave devices perform routine environmental evaluation for RF Exposure to demonstrate compliance. In addition, spread spectrum transmitters operating under Section 15.247 are required to address RF Exposure compliance in accordance with Section 15.247(b)(4). Thank you. Company name: Beijing Roborock Technology Co., Ltd. Name: Ruby Hu Tel: +86 01053241660 Signature:


Document Created: 2018-06-26 15:07:29
Document Modified: 2018-06-26 15:07:29
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC