Test Report

FCC ID: 2AMNM-NC100

Test Report

Download: PDF

                            ®
  A\G
                                & T I& micg

                                Attestation of Global Compliance                                                         Report No.: AGC01518190402FEO3
                                                                                                                                                              Page 51 of 76


    12. TIME OF OCCUPANCY (DWELL TIME)
    12.1. MEASUREMENT PROCEDURE
    The EUT shall have its hopping function enabled. Use the following spectrum analyzer settings:
    1. Span: Zero span, centered on a hopping channel.
    2. RBW shall be=channel spacing and where possible RBW should be set >> 1 / T, where T is the expected
    dwell time per channel.
    3. Sweep: As necessary to capture the entire dwell time per hopping channel; where possible use a video
    trigger and trigger delay so that the transmitted signal starts a little to the right of the start of the plot. The
    trigger level might need slight adjustment to prevent triggering when the system hops on an adjacent channel;
    a second plot might be needed with a longer sweep time to show two successive hops on a channel.
    4. Detector function: Peak. Trace: Max hold.
    5. Use the marker—delta function to determine the transmit time per hop.
    6. Repeat the measurement using a longer sweep time to determine the number of hops over the period
    specified in the requirements. The sweep time shall be equal to, or less than, the period specified in the
    requirements. Determine the number of hops over the sweep time and calculate the total number of hops in
    the period specified in the requirements, using the following equation:
     {(Number of hops in the period specified in the requirements) = (number of hops on spectrum analyzer) x
    (period specified in the requirements / analyzer sweep time)
    7. The average time of occupancy is calculated from the transmit time per hop multiplied by the number of
    hops in the period specified in the requirements.
    12.2. TEST SETUP (BLOCK DIAGRAM OF CONFIGURATION)

       Same as described in section 8.2


    12.3. MEASUREMENT EQUIPMENT USED
       The same as described in section 6


    12.4. LIMITS AND MEASUREMENT RESULT
                                  Ti     f Pul
          Channel                   m;iroDH: se                Number of hops in the period                                  Sweep Time                             Limit
                                                               specified in the requirements                                    (ms)                                (ms)
                                          (ms)
                Low                      2.867                                       27*4                                        309.636                             400

            Middle                       2.858                                       31*4                                        354.392                             400

             High                        2.858                                       30*4                                        342.960                             400

    Note: The 8—DPSK modulation is the worst case and recorded in the report.




The results ’m,6tison|
                  o thisfeaes report refer only to the sample(s) tested unless otherwise stated and the sample(s) are retained for 30 days only. The document
is issued by/A 6§€ this doc(fiao it cannot be reproduced except in full with our prior written permission. The more details and the authenticity of the report will be
confirmed t;!?ttp://www.agc-«drS t.com.
            o

                                                       Tel: +86—755 2908 1955           Fax: +86—755 2600 8484             E—mail: agc@age—cert.com             @ 400 089 2118
                                                      Add: 2/F. , Building 2, No.1—4, Chaxi Sanwei Technical Industrial Park,Gushu, Xixiang, Bacan District, Shenzhen, Guangdong China


                           Report No.: AGC01518190402FE03
                                               Page 52 of 76


TEST PLOT OF LOW CHANNEL


                              Report No.: AGC01518190402FE03
                                                  Page 53 of 76


TEST PLOT OF MIDDLE CHANNEL


                            Report No.: AGC01518190402FE03
                                                Page 54 of 76


TEST PLOT OF HIGH CHANNEL


                            ®
  A\G
                                     & T I&   micg

                                     Attestation of Global Compliance                                                                              Report No.: AGC01518190402FEO3
                                                                                                                                                                                  Page 55 of 76


    13. FREQUENCY SEPARATION
    13.1. MEASUREMENT PROCEDURE
    The EUT shall have its hopping function enabled. Use the following spectrum analyzer settings:
    1. Span: Wide enough to capture the peaks of two adjacent channels.
    2. RBW: Start with the RBW set to approximately 30%of the channel spacing; adjust as necessary to best
    identify the center of each individual channel.
    3. Video (or average) bandwidth (VBW) > RBW.
    4. Sweep: Auto. e) Detector function: Peak. f) Trace: Max hold. g) Allow the trace to stabilize.
    Use the marker—delta function to determine the separation between the peaks of the adjacent channels.
    13.2. TEST SETUP (BLOCK DIAGRAM OF CONFIGURATION)
       Same as described in section 6.2
    13.3. MEASUREMENT EQUIPMENT USED
       The same as described in section 6.3
    13.4. LIMITS AND MEASUREMENT RESULT

                                                           pHANNEE                                                     LIMIT                                                RESULT
             CHANNEL                                   SEPARATION
                                                                    KHz                                                 KHz
                                                                                                                                                                                Pass
            CHO1—CHO2                                               1000                        >=25 KHz or 2/3 20 dB BW

                                                              TEST PLOT FOR FREQUENCY SEPARATION
                          BM Agilent Spectrum Analyzer — Swept SA
                                                                                          |__SENSEINT              |     ALIGN AUTO     ___|03:03:14 PM Apr28, 2019   Eon   e
                          Marker 2 2.403165000000 GHz                                                         Avg Type: Log—Pwr                Tc   e
                                                                                                                                                tyRig
                                                                                                                                                                      ie
                                                                                                                                                                      Eie
                                                                       PNO: Wide C J   Trig: Free Run         AvgiHold:>100/100
                                                                       IFGain:Low      Atten: 30 dB                                               Det



                                              Ref 20.00 dBm




                          Start 2400000 GHz                                                                                    Stop 2405000 GHz
                          #Res BW 100 kHz                                   #VEBW 300 kHz                                Sweep 1.000 ms (1001 pts)
                           MKR] MODE TRC) SCL                                                           FUNCTION       FUNCTION WIDTH       FUNCTION VALUE        *
                             1 III--                            P402 165 GHz           O595 dBm
                                                                2403 165 GHz           OHiecmn




The results shW              R
is issued by/A6§€ this dOCL( ent cannot be reproduced except in full with our prior written permission. The more details and the authenticity ofthe report will be
confirmed tfittp UIwww. agcoge t.com.



Attestatic                       o        i                          Tel: +86—755 2908 1955              Fax: +86—755 2600 8484                      E—mail: agc@age—cert.com      @ 400 089 2118
                                                                    Add: 2/F. , Building 2, No.1—4, Chaxi Sanwei Technical Industrial Park,Gushu, Xixiang, Bacan District, Shenzhen, Guangdong China


                                   Report No.: AGC01518190402FE03
                                                       Page 56 of 76


APPENDIX A: PHOTOGRAPHS OF TEST SETUP
 RADIATED EMISSION TEST SETUP BELOW 1GHZ




 RADIATED EMISSION TEST SETUP ABOVE 1GHZ


                           Report No.: AGC01518190402FE03
                                               Page 57 of 76


APPENDIX B: PHOTOGRAPHS OF EUT
        ALL VIEW OF EUT




        TOP VIEW OF EUT


                     Report No.: AGC01518190402FE03
                                         Page 58 of 76


BOTTOM VIEW OF EUT




FRONT VIEW OF EUT


                   Report No.: AGC01518190402FE03
                                       Page 59 of 76


BACK VIEW OF EUT




LEFT VIEW OF EUT


                    Report No.: AGC01518190402FE03
                                        Page 60 of 76


RIGHT VIEW OF EUT




      Left
OPEN VIEW OF EUT


                         Report No.: AGC01518190402FE03
                                             Page 61 of 76


INTERNAL VIEW OF EUT-1




INTERNAL VIEW OF EUT-2


                         Report No.: AGC01518190402FE03
                                             Page 62 of 76


INTERNAL VIEW OF EUT-3




INTERNAL VIEW OF EUT-4


                         Report No.: AGC01518190402FE03
                                             Page 63 of 76


INTERNAL VIEW OF EUT-5




                                         Antenna




        Right
 OPEN VIEW OF EUT-1


                         Report No.: AGC01518190402FE03
                                             Page 64 of 76


 OPEN VIEW OF EUT-2




INTERNAL VIEW OF EUT-1


                         Report No.: AGC01518190402FE03
                                             Page 65 of 76


INTERNAL VIEW OF EUT-2




INTERNAL VIEW OF EUT-3


                         Report No.: AGC01518190402FE03
                                             Page 66 of 76


INTERNAL VIEW OF EUT-4




INTERNAL VIEW OF EUT-5




                               Antenna


                  Report No.: AGC01518190402FE03
                                      Page 67 of 76


ALL VIEW OF EUT




TOP VIEW OF EUT


                     Report No.: AGC01518190402FE03
                                         Page 68 of 76


BOTTOM VIEW OF EUT




FRONT VIEW OF EUT


                   Report No.: AGC01518190402FE03
                                       Page 69 of 76


BACK VIEW OF EUT




LEFT VIEW OF EUT


                    Report No.: AGC01518190402FE03
                                        Page 70 of 76


RIGHT VIEW OF EUT




       Lift
OPEN VIEW OF EUT


                         Report No.: AGC01518190402FE03
                                             Page 71 of 76


INTERNAL VIEW OF EUT-1




INTERNAL VIEW OF EUT-2


                         Report No.: AGC01518190402FE03
                                             Page 72 of 76


INTERNAL VIEW OF EUT-3




INTERNAL VIEW OF EUT-4


                         Report No.: AGC01518190402FE03
                                             Page 73 of 76


INTERNAL VIEW OF EUT-5




INTERNAL VIEW OF EUT-6




                                  Antenna


                         Report No.: AGC01518190402FE03
                                             Page 74 of 76


        Right
  OPEN VIEW OF EUT




INTERNAL VIEW OF EUT-1


                         Report No.: AGC01518190402FE03
                                             Page 75 of 76


INTERNAL VIEW OF EUT-2




INTERNAL VIEW OF EUT-3


                         Report No.: AGC01518190402FE03
                                             Page 76 of 76


INTERNAL VIEW OF EUT-4




INTERNAL VIEW OF EUT-5




                         Antenna




----END OF REPORT----



Document Created: 2019-05-15 10:18:07
Document Modified: 2019-05-15 10:18:07

© 2019 FCC.report
This site is not affiliated with or endorsed by the FCC