RF exposure

FCC ID: 2AMDJ-RS460

RF Exposure Info

Download: PDF
FCCID_4024011

 RF Exposure Report


 FCC-ID: 2AMDJ-RS460

 RF Exposure Measurement

 The limit for Maximum Permissible Exposure (MPE) specified in FCC 1.1310 is followed. The
 gain of the antennas used in the product is extracted from the Antenna data sheets provided
 and also the maximum total power input to the antenna is measured. Through the Friis
 transmission formula and the maximum gain of the antenna, we can calculate the distance,
 away from the product, where the limit of MPE is reached.
 Although the Friis Transmission formula is far field assumption, the calculated result of that is
 an over-prediction for near field power density. It is taken as worst case to specify the safety
 range.



 RF Exposure Limit

 According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the
 environmental impact of the human exposure to radio-frequency (RF) radiation as specified in
 1.1307 (b)



Frequency Range            Electric Field               Magnetic Field             Power Density
(MHz)                      Strength (V/m)               Strength (A/m)             (mW/cm²)
Limits for Occupational / controlled Exposures
300 - 1500                 --                           --                         F/300
1500 – 100000              --                           --                         5.0
Limits for General population / Uncontrolled Exposure
300 - 1500                 --                           --                         F/1500
1500 – 100000              --                           --                         1.0



 Limits for Maximum Permissible Exposure (MPE)



 F= Frequency in MHz


 Friss Formula

Friss Transmission Formula: Pd = (Pout * G) / (4*pi*r²)


Where
Pd = power density in mW/cm²
Pout = output power to antenna in mW
G = gain of antenna in linear scale
Pi = 3.1416
R = Distance between observation point and the center of radiator in cm


If we know the maximum gain of the antenna and the total output power to the antenna,
through calculation, we will know MPE value at distance 20cm.


EUT Operation condition

EUT was enabled to transmit and receive at lowest, middle and highest channels.


Classification

The antenna of this product, under normal use condition, is at least 20cm away from the body of the
user. Warning statement to the user for keeping at least 20cm or more separation distance from the
antenna should be included in the User manual. So, this device is classified as Mobile device.
457-467MHz
Mode               457-467MHz
Detector           Maximun Transmitter Power
GMSK               33±0.5dBm


ANT Gain (G)
Antenna gain : 3dBi (gain of antenna in linear scale=2)


                                           Output
                                 Channel            Output
                ANT Gain(gain of          Power to            Power
                                 Frequenc          Power to            Limit
  Protocol         antenna in        y
                                          Antenna
                                                   Antenna
                                                             Density
                                                                     (mW/cm²)
                  linear scale)    (MHz)
                                           (dBm)
                                                     (mW)
                                                            (mW/cm²)

    GMSK                   2                462           33.5 2238.72         0.89121           1.52



Document Created: 2018-09-28 10:30:22
Document Modified: 2018-09-28 10:30:22

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC