Test Report-NII-Part 2

FCC ID: 2AL6KBL-R8812RD3

Test Report

Download: PDF
FCCID_4438454

Report No.: GTS20190613008-1-8 Page 54 of 75 4.7. 26dBc Bandwidth TEST CONFIGURATION SPECTRUM EUT ANALYZER TEST PROCEDURE According to KDB789033 D02 General UNII Test Procedures New Rules v01 for one of the following procedures may be used for Emission Bandwidth (EBW) measurement: a. Set RBW = 300 kHz (approximately 1% of the emission bandwidth). b. Set the video bandwidth (VBW) = 1000 KHz (VBW > RBW) c. Detector = Peak. d. Trace mode = max hold. e. Sweep = auto couple. f. Allow the trace to stabilize g. Measure the maximum width of the emission that is 26 dB down from the maximum of the emission. Compare this with the RBW setting of the analyzer. Readjust RBW and repeat measurement as needed until the RBW/EBW ratio is approximately 1%. Note: The automatic bandwidth measurement capability of a spectrum analyzer or EMI receiver may be employed if it implements the functionality described above. LIMIT No Limits for 26dBc Bandwith TEST RESULTS

Report No.: GTS20190613008-1-8 Page 55 of 75 Antenna 0 99%Bandwidth 26dB Bandwidth Type Channel Limit (KHz) Result (MHz) (MHz) 36 16.86 21.58 802.11a 40 16.86 21.32 - Pass 48 16.78 21.28 36 17.90 22.04 802.11nHT20 40 17.90 22.00 - Pass 48 17.94 22.20 36 17.90 22.00 802.11ac20 40 17.90 22.08 - Pass 48 17.94 21.96 38 36.68 44.00 802.11n40 - Pass 46 36.60 44.12 38 36.52 43.24 802.11ac40 - Pass 46 36.52 43.40 802.11ac80 42 75.12 82.08 - Pass Antenna 1 99%Bandwidth 26dB Bandwidth Type Channel Limit (KHz) Result (MHz) (MHz) 36 16.86 21.34 802.11a 40 16.86 21.40 - Pass 48 16.78 21.20 36 17.90 22.16 802.11nHT20 40 17.90 21.96 - Pass 48 17.94 22.32 36 17.94 22.08 802.11ac20 40 17.94 22.16 - Pass 48 17.94 22.04 38 36.68 44.16 802.11n40 - Pass 46 36.60 44.28 38 36.52 43.40 802.11ac40 - Pass 46 36.52 43.48 802.11ac80 42 75.12 82.24 - Pass

Report No.: GTS20190613008-1-8 Page 56 of 75 Antenna 0 802.11a 802.11n HT20 CH36 CH36 CH40 CH40 CH48 CH48

Report No.: GTS20190613008-1-8 Page 57 of 75 802.11ac20 802.11n HT40 CH36 CH38 CH40 CH46 CH48

Report No.: GTS20190613008-1-8 Page 58 of 75 802.11ac40 802.11ac80 CH38 CH42 CH46

Report No.: GTS20190613008-1-8 Page 59 of 75 Antenna 1 802.11a 802.11n HT20 CH36 CH36 CH40 CH40

Report No.: GTS20190613008-1-8 Page 60 of 75 CH48 CH48 802.11ac20 802.11n HT40 CH36 CH38 CH40 CH46 CH48

Report No.: GTS20190613008-1-8 Page 61 of 75 802.11ac40 802.11ac80 CH38 CH42 CH46

Report No.: GTS20190613008-1-8 Page 62 of 75 4.8. Band Edge Compliance TEST CONFIGURATION LIMIT 20dBc in any 100 kHz bandwidth outside the operating frequency band. In case the emission fall within the restricted band specified on 15.205(a), then the 15.209(a) limit in the table below has to be followed. Frequency (MHz) Distance Radiated (dBμV/m) Radiated (μV/m) (Meters) 0.009-0.49 3 20log(2400/F(KHz))+40log(300/3) 2400/F(KHz) 0.49-1.705 3 20log(24000/F(KHz))+ 40log(30/3) 24000/F(KHz) 1.705-30 3 20log(30)+ 40log(30/3) 30 30-88 3 40.0 100 88-216 3 43.5 150 216-960 3 46.0 200 Above 960 3 54.0 500 According to §15.407 (b): Except as shown in paragraph (b)(7) of this section, the maximum emissions outside of the frequency bands of operation shall be attenuated in accordance with the following limits Frequency (MHz) EIRP Limit (dBm) Equivalent Field Strength at 3m (dBµV/m) 5150-5250 -27 68.2 5250-5350 -27 68.2 5470-5725 -27 68.2 -27 (beyond 10MHz of the bandedge) 68.2 5725-5850 -17 (within 10 MHz of band edge) 78.2 TEST PROCEDURE 1. The EUT was placed on a turn table which is 1.5m above 1GHz. 2. Maximum procedure was performed by raising the receiving antenna from 1m to 4m and rotating the turn table from 0° to 360° to acquire the highest emissions from EUT. 3. And also, each emission was to be maximized by changing the polarization of receiving antenna both horizontal and vertical. 4. Repeat above procedures until all frequency measurements have been completed.. 5. The distance between test antenna and EUT as following table states: Test Frequency range Test Antenna Type Test Distance 1GHz-18GHz Double Ridged Horn Antenna 3

Report No.: GTS20190613008-1-8 Page 63 of 75 6. Setting test receiver/spectrum as following table states: Test Frequency range Test Receiver/Spectrum Setting Detector Peak Value: RBW=1MHz/VBW=3MHz, Sweep time=Auto 1GHz-18GHz Peak Average Value: RBW=1MHz/VBW=10Hz, Sweep time=Auto Field Strength Calculation The field strength is calculated by adding the Antenna Factor and Cable Factor and subtracting the Amplifier Gain and Duty Cycle Correction Factor(if any) from the measured reading. The basic equation with a sample calculation is as follows: FS = RA + AF + CL - AG Where FS = Field Strength CL = Cable Attenuation Factor (Cable Loss) RA = Reading Amplitude AG = Amplifier Gain AF = Antenna Factor TEST RESULTS Remark:For radiated bandedge We measured at both mode, recorded worst case at MIMO 802.11 a mode; For Radiated Bandedge Measurement 802.11 a/ Channel 36 :5180 MHz Read Antenna PRM Cable Result Limit Freq Margin Level Factor Factor Loss Level Line Detector Polarization (MHz) (dB) (dBµV) (dB/m) (dB) (dB) (dBµV/m) (dBµV/m) 5148.26 35.24 35.58 29.04 8.28 50.06 74 23.94 Peak Horizontal 5148.26 24.45 35.58 29.04 8.28 39.27 54 14.73 AV Horizontal 802.11 a/ Channel 48 :5240 MHz Read Antenna PRM Cable Result Limit Freq Margin Level Factor Factor Loss Level Line Detector Polarization (MHz) (dB) (dBµV) (dB/m) (dB) (dB) (dBµV/m) (dBµV/m) 5353.12 35.62 35.42 29.06 8.39 50.37 74 23.63 Peak Horizontal 5353.12 25.35 35.42 29.06 8.39 40.10 54 13.90 AV Horizontal 802.11 a/ Channel 149 :5745 MHz Read Antenna PRM Cable Result Limit Freq Margin Level Factor Factor Loss Level Line Detector Polarization (MHz) (dB) (dBµV) (dB/m) (dB) (dB) (dBµV/m) (dBµV/m) 5713.23 39.81 35.29 29.13 8.65 54.62 110.73 49.93 Peak Horizontal 802.11 a/ Channel 165 :5825 MHz Read Antenna PRM Cable Result Limit Freq Margin Level Factor Factor Loss Level Line Detector Polarization (MHz) (dB) (dBµV) (dB/m) (dB) (dB) (dBµV/m) (dBµV/m) 5877.19 40.50 35.29 29.18 8.80 55.41 103.58 57.49 Peak Horizontal REMARKS: 1. Result Level = Read Level + Antenna Factor + Cable loss - PRM Factor. 2. The other emission levels were very low against the limit. 3. The average measurement was not performed when the peak measured data under the limit of average detection. 4. Detector AV is setting spectrum/receiver. RBW=1MHz/VBW=10Hz/Sweep time=Auto/Detector=Peak;

Report No.: GTS20190613008-1-8 Page 64 of 75 For Conducted Band edge Measurement Note:each antenna port have 3dB margin from the limit,so the MIMO mode below the limit. The test results have included the antenna gain Antenna 0 5150-5250MHz: 802.11a 5180 MHz 5240 MHz 802.11n HT20 5180 MHz 5240 MHz

Report No.: GTS20190613008-1-8 Page 65 of 75 802.11ac20 5180 MHz 5240 MHz 802.11n HT40 5190 MHz 5230 MHz 802.11ac40 5190 MHz 5230 MHz

Report No.: GTS20190613008-1-8 Page 66 of 75 802.11ac80 5210 MHz 5210 MHz 5725-5850MHz: 802.11a 5745 MHz 5825 MHz 802.11n HT20

Report No.: GTS20190613008-1-8 Page 67 of 75 5745 MHz 5825 MHz 802.11ac20 5745 MHz 5825 MHz 802.11n HT40 5755 MHz 5795 MHz 802.11ac40 5755 MHz 5795 MHz

Report No.: GTS20190613008-1-8 Page 68 of 75 802.11ac80 5775 MHz 5775 MHz Antenna 1 5150-5250MHz: 802.11a 5180 MHz 5240 MHz 802.11n HT20

Report No.: GTS20190613008-1-8 Page 69 of 75 5180 MHz 5240 MHz 802.11ac20 5180 MHz 5240 MHz 802.11n HT40 5190 MHz 5230 MHz 802.11ac40 5190 MHz 5230 MHz

Report No.: GTS20190613008-1-8 Page 70 of 75 802.11ac80 5210 MHz 5210 MHz 5725-5850MHz: 802.11a 5745 MHz 5825 MHz 802.11n HT20

Report No.: GTS20190613008-1-8 Page 71 of 75 5745 MHz 5825 MHz 802.11ac20 5745 MHz 5825 MHz 802.11n HT40 5755 MHz 5795 MHz 802.11ac40 5755 MHz 5795 MHz

Report No.: GTS20190613008-1-8 Page 72 of 75 802.11ac80 5775 MHz 5775 MHz

Report No.: GTS20190613008-1-8 Page 73 of 75 4.9. Antenna Requirement Standard Applicable For intentional device, according to FCC 47 CFR Section 15.203, an intentional radiator shall be designed to ensure that no antenna other than that furnished by the responsible party shall be used with the device. And according to FCC 47 CFR Section 15.407 (a), if transmitting antennas of directional gain greater than 6dBi are used, the power shall be reduced by the amount in dB that the directional gain of the antenna exceeds 6dBi. Antenna Information The antenna is PCB antenna, through the buckle stretched out, The directional gains of antenna used for transmitting is 2.00dBi. Reference to the test report No. GTS20190613008-1-7

Report No.: GTS20190613008-1-8 Page 74 of 75 5. TEST SETUP PHOTOS OF THE EUT Radiated Emission Test Conducted Emission

Report No.: GTS20190613008-1-8 Page 75 of 75 6. EXTERNAL AND INTERNAL PHOTOS OF THE EUT Please refer to separated files for External and Internal Photos of the EUT. .......................End of Report.........................


Document Created: 2019-09-11 18:06:15
Document Modified: 2019-09-11 18:06:15
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC