Request Modular Transmitter Approval

FCC ID: 2AL6K-R8188NU3

Cover Letter(s)

Download: PDF
FCCID_4170861

ShenZhen BiLian Electronic Co.,Ltd. Building B1, Zhongxing Industrial Zone, Juling, Jutang Community, Guanlan street, LongHua district, Shenzhen, Guangdong, P.R.China Modular Approval Letter 2019-01-22 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subjects: Modular Approval Letter The Device,FCC ID: 2AL6K-R8188NU3, is seeking FCC authorization as a modular transmitter. The EUT meets the requirement for modular approval as detailed in FCC Public Notice DA 00-1407. Compliance to each of the requirement is described below: (a) The radio elements must have the radio frequency circuitry be shielded. Physical/discrete and tuning capacitors may be located external to the shield, but must be on the module assembly. The modular has no RF shielding. (b) The module shall have buffered modulation/data input(s) (if such inputs are provided) to ensure that the module will comply with the requirements set out in the applicable RSS standard under conditions of excessive data rates or over-modulation. Yes. (c) The module shall have its own power supply regulation on the module. This is to ensure that the module will comply with the requirements set out in the applicable standard regardless of the design of the power supplying circuitry in the host device which houses the module. The modular has an onboard 3.3V regulator(integrated in RTL8812AU). (d) The module shall comply with the provisions for external power amplifiers and antennas detailed in this standard. The equipment certification submission shall contain a detailed description of the configuration of all antennas that will be used with the module. The modular has external antennas which comply with the antenna requirement of Section 15.203. (e) The module shall be tested for compliance with the applicable standard in a stand-alone configuration, i.e. the module must not be inside another device during testing. The modular was tested in a standalone configuration apart from host units.

(f) The module shall comply with the Category I equipment labeling requirements and CFR § 15.212(a)(1)(vi). The modular has its own FCC ID number. (g) The module shall comply with any applicable FCC RF exposure requirement which are based on the intended use/configurations. Yes，the module is intended to use in distance greater that 20cm. FCC RF exposure requirement satisfied with 47CFR §2.1091. (h) The modular transmitter complies with all applicable FCC rules. Instructions for maintaining compliance are given in the user instructions. Yes If you have any questions, please feel free to contact us at the address shown below Sincerely, (Signed) Name: Hanbing Deng /Manager Company: ShenZhen BiLian Electronic Co.,Ltd. Address: Building B1, Zhongxing Industrial Zone, Juling, Jutang Community, Guanlan street, LongHua district, Shenzhen, Guangdong, P.R.China Phone: 18118768735 Fax: 0755-24665666 E-Mail: 516371599@qq.com


Document Created: 2019-03-28 05:09:21
Document Modified: 2019-03-28 05:09:21
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC