Modular Approval_FCC

FCC ID: 2AJVQ-MT7601U-M

Cover Letter(s)

Download: PDF
FCCID_3905595

Qingdao Intelligent&Precise Electronics Co., Ltd No.218, Qianwangang Road, Qingdao Economic&Technological Development Zone, Shandong, China. Modular Approval Request Letter FCC ID: 2AJVQ- MT7601U-M Date: 2018.6.11 There’s a Wireless Module that would like to have your authorization as a modular approval. The specific product as below, Wireless Module with its designed features and specified description, meets special requirements for limited modular approval on FCC Public Notice KDB996369 Released: October 23, 2015 by cross-reference list below. Company : Qingdao Intelligent&Precise Electronics Co., Ltd Model Name : Wireless Module Model Number : ZDGFMT7601U-M FCC ID : 2AJVQ-MT7601U-M Modular approval requirement Answer 1. The radio elements must have the radio frequency circuitry shielded. The module has its own RF shielding. Physical components and tuning capacitor(s) may be located external to Refer to the External Photos. the shield, but must be on the module assembly; 2. The module must have buffered modulation/data inputs to ensure The EUT has buffered modulation/data inputs, it’s integrated in that the device will comply with Part 15 requirements with any type the chip U2:MT7601U. of input signal; Refer to the Schematic Diagram. 3. The module must contain power supply regulation on the module; The module doesn’t have its own power supply regulation. 4. The module must contain a permanently attached antenna, or contain a The module uses PIFA antenna. Please refer to External photo. unique antenna connector, and be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b), 15.204(c), 15.212(a), 2.929(b); 5. The module must demonstrate compliance in a stand-alone configuration; The module was tested in a stand-alone configuration. Please refer to Test Setup photo. 6. The module must be labelled with its permanently affixed FCC ID label, or The module is labeled with its own FCC ID number. Please use an electronic display (See KDB Publication 784748 about labelling refer to Label. requirements); 7. The module must comply with all specific rules applicable to the The module complies with this requirement. Please refer to transmitter including all the conditions provided in the integration user manual. instructions by the grantee; 8. The module must comply with RF exposure requirements. The module complies with this requirement. Please refer to MPE report. Thank you. Sincerely, Caifeng Li Qingdao Intelligent&Precise Electronics Co.,Ltd Tel: 86 532 80879444 Fax: -- Email: licaifeng@hisense.com


Document Created: 2019-09-21 19:38:54
Document Modified: 2019-09-21 19:38:54
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC