FCC-Modular-Approval-Letter_Rev 1

FCC ID: 2AJVQ-7668AUC

Cover Letter(s)

Download: PDF
FCCID_4291250

Qingdao Intelligent&Precise Electronics Co., Ltd No.218, Qianwangang Road, Qingdao Economic&Technological Development Zone, Shandong, China. RE FCC ID: 2AJVQ-7668AUC To the certification reviewer: We are hereby applying for full modular approval of the above-referenced FCC ID, based on compliance with all of the criteria as detailed below. Part 15 Unlicensed Single Modular Transmitter Approval Justification per 15.212 Requirement per 15.212 reference (i) The radio elements of the modular transmitter Shielding is provided by a metal cover over the circuitry. must have their own RF shielding. (ii) The modular transmitter must have buffered All modulation and data inputs are buffered by circuitry modulation/data inputs (if such inputs are on the transmitter chip U1, as is shown in the schematic. provided. (iii) The modular transmitter must have its own Power supply regulation is provided by circuitry on the power supply regulation. transmitter chip U2, as is shown in the schematic. (iv) The modular transmitter must comply with the The antenna is permanently attached. antenna and transmission system requirements of §§15.203, 15.204(b) and 15.204(c). (v) The modular transmitter must be tested in a Testing was performed in a stand-alone configuration, as stand-alone configuration, i.e., the module must shown in the test setup photos. not be inside another device during testing for compliance with Part 15 parameters. (vi) The modular transmitter must be equipped with The module is labeled with its own FCC ID number. either a permanently affixed label or must be Please refer to Label. capable of electronically displaying its FCC identification number. If the FCC ID is not If the FCC ID is not visible when the module is installed visible when the module is installed inside inside another device, than the device should label as another device, then the outside of the device below: into which the module is installed must also Contains transmitter module FCC ID:2AJVQ-7668AUC display a label referring to the enclosed module. (vii) The modular transmitter must comply with any The module complies with this requirement. Please refer specific rules or operating requirements that to user manual. ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. (viii) The modular transmitter must comply with any The module complies with this requirement. Please refer applicable RF exposure requirements in its final to MPE report. configuration. Sincerely, [signature] [name] Caifeng Li [title] Quality Engineer


Document Created: 2019-05-22 16:06:27
Document Modified: 2019-05-22 16:06:27
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC