TempConfidential_EN_LATAM_711608024881_Nokia_x_QSG_issue_1

FCC ID: 2AJOTTA-1133

Users Manual

Download: PDF
FCCID_4178364

Get Started Headset connector Nokia xx Camera Flash Front camera Fingerprint sensor Earpiece SIM and memory card slot Google Assistant/ Google search key* USB connector Loudspeaker Volume keys Microphone Power/Lock key *Google Assistant is available in selected markets and languages. Where not available Google Assistant TA-1133/TA-1149 EN-LATAM is replaced by Google Search. 1. Insert the SIM and memory 2. Charge the battery and switch card the phone on 1.Open the SIM and memory card tray: push the Plug a compatible charger into a wall outlet, and tray opener pin in the tray hole and slide the tray connect the cable to your phone. Your phone sup- out. ports the USB micro-B cable. You can also charge 2.Put the nano-SIM in slot 1 on the tray with the your phone from a computer with a USB cable, but contact area face down. If you have a second SIM, it may take a longer time. put it in slot 2. If the battery is completely discharged, it may take several minutes before the charging indicator is dis- 3.If you have a memory card, put it in the memory played. card slot. To switch your phone on, press and hold the power 4.Slide the tray back in. key until the phone vibrates. The phone guides you Use only original nano-SIM cards. Use of incompati- through the setup. ble SIM cards may damage the card or the device, and may corrupt data stored on the card. Use only compatible memory cards approved for use with this device. Incompatible cards may dam- age the card and the device and corrupt data stored on the card. Important: Do not remove the memory card when an app is using it. Doing so may damage the memory card and the device and corrupt data For an online user guide and troubleshooting help, stored on the card. go to www.nokia.com/mobile-support. Both SIM cards are available at the same time when the device is not being used, but while one SIM card is active, for example, making a call, the other may be unavailable. 711608024881 V1.0 xxxxxxxxxx

Product and safety info is 0.40 W/kg, and when worn on the body in a holder or carry case, is 1.16 W/kg. on a scale from one to four, where four is the most compatible. Your phone meets the M4/T4 level rating. Important: For important info on the safe use of your device and battery, read the Product and safety info booklet before you take Body-worn Operation; This device was tested for typical body-worn However, hearing aid compatibility ratings don't guarantee that your device into use. operations with the handset kept 1.0 cm from the body. To maintain interference to your hearing aids won't happen. Results will vary, compliance with FCC RF exposure requirements, use accessories that depending on the level of immunity of your hearing device and the booklet before you take your device into use. maintain a 1.0 cm separation distance between the user’s body and degree of your hearing loss. If your hearing device happens to be You can only use your device on the GSM 850, 900, 1800, 1900; the handset. The use of belt clips, holsters and similar accessories vulnerable to interference, you may not be able to use a rated phone WCDMA 1, 2, 4, 5, 8; LTE 1, 2, 3, 4, 5, 7, 8, 12, 17, 28, 38, 66 networks. should not contain metallic components in its assembly. The use of successfully. Trying out the phone with your hearing device is the You need a subscription with a service provider. accessories that do not satisfy these requirements may not comply best way to evaluate it for your personal needs. with FCC RF exposure requirements, and should be avoided. The FCC This phone has been tested and rated for use with hearing aids for Important: 4G/LTE might not be supported by your network has granted an Equipment Authorization for this model handset with service provider or by the service provider you are using when some of the wireless technologies that it uses. However, there may all reported SAR levels evaluated as in compliance with the FCC RF be some newer wireless technologies used in this phone that have traveling. In these cases, you may not be able to make or receive emission guidelines. SAR information on this model handset is on file calls, send or receive messages or use mobile data connections. To not been tested yet for use with hearing aids. It is important to try the with the FCC and can be found under the FCC ID Search section of different features of this phone thoroughly and in different make sure your device works seamlessly when full 4G/LTE service is www.fcc.gov/oet/ea/ after searching on FCC ID 2AJOTTA-1133 or not available, it is recommended that you change the highest locations, using your hearing aid or cochlear implant, to determine if 2AJOTTA-1149. you hear any interfering noise. Consult your service provider or the connection speed from 4G to 3G. To do this, on the home screen, tap Settings > Network & Internet > Mobile network > Advanced, and Additional information on Specific Absorption Rates (SAR) can be manufacturer of this phone for information on hearing aid switch Preferred network type to 3G. found on the FCC website at www.fcc.gov/general/radio-frequency- compatibility. If you have questions about return or exchange safety-0. policies, consult your service provider or phone retailer. For more info, contact your network service provider. To send data or messages, a good connection to the network is Hearing devices may also be rated. Your hearing device manufacturer Your device has an internal, non-removable, rechargeable battery. needed. Sending may be delayed until such a connection is available. or hearing health professional may help you find this rating. For more Do not attempt to remove the battery or back cover, as you may Follow the separation distance instructions until the sending is information about FCC Hearing Aid Compatibility, please go to http:/ damage the device. To replace the battery, take the device to the finished. /www.fcc.gov/cgb/dro. nearest authorised service facility. During general use, the SAR values are usually well below the values This device has an electronic label for certification information. To Charge your device with the CH-35E (EU plug)/CH-35 X (UK plug)/ CH- stated above. This is because, for purposes of system efficiency and access it, select Settings > System > Certification. 35U (US plug)/ CH-35A (Australia plug)/ CH-35N (India plug) chargers. to minimise interference on the network, the operating power of your HMD Global may make additional battery or charger models available mobile is automatically decreased when full power is not needed for © 2019 HMD Global. HMD Global Oy is the exclusive licensee of the for this device. Charging time can vary depending on device the call. The lower the power output, the lower the SAR value. Nokia brand for phones & tablets. Nokia is a registered trademark of capability. Some of the accessories mentioned in this user guide, Nokia Corporation. such as charger, headset, or data cable, may be sold separately. Device models may have different versions and more than one value. Component and design changes may occur over time and some Google, Google Assistant and other marks are trademarks of Google Electrical Information of the Charger changes could affect SAR values. LLC. The following electrical information corresponds to the above- For more info, go to www.sar-tick.com. Note that mobile devices mentioned charger models: may be transmitting even if you are not making a voice call. Input: 100-240 Vca 50-60 Hz 0-200 mA Your mobile device is also designed to meet the United States Output: 5,0 Vcc 0-1000 mA Federal Communications Commission (FCC) guidelines. FCC ratings Charger safety instructions for your device and more information on SAR can be found at http:/ /transition.fcc.gov/oet/rfsafety/sar.html. The charger is suitable to be used only with compatible devices. The World Health Organization (WHO) has stated that current The charger should not be used in extremely high or low scientific information does not indicate the need for any special temperatures. precautions when using mobile devices. If you are interested in Ventilation should not be obstructed by covering the charger with reducing your exposure, they recommend you limit your usage or use magazines, blankets, curtains etc. a hands-free kit to keep the device away from your head and body. Open flames, such as candles, should not be placed above the For more information and explanations and discussions on RF charger. exposure, go to the WHO website at www.who.int/peh-emf/en. The charger and the wall outlet shall be easily accessible at all times. In case the cable or the plugs are damaged, stop using it. Copyrights and other notices The charger requires very low maintenance. If you want to clean it, use a dry cloth or a brush. FCC notice: Meaning of the symbols: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause For internal use only harmful interference, and (2) this device must accept any The charger should not be disposed as unsorted municipal interference received, including interference that may cause waste. It should be recycled. undesired operation. For more info, go to www.fcc.gov/engineering- technology/electromagnetic-compatibility-division/radio- frequency-safety/faq/rf-safety. Any changes or modifications not The surface of the device is nickel-free. expressly approved by HMD Global could void the user’s authority to Parts of the device are magnetic. Metallic materials may be attracted operate this equipment. Note: This equipment has been tested and to the device. Do not place credit cards or other magnetic stripe found to comply with the limits for a Class B digital device, pursuant cards near the device for extended periods of time, since the cards to part 15 of the FCC Rules. These limits are designed to provide may be damaged. reasonable protection against harmful interference in a residential Note: Pre-installed system software and apps use a significant installation. This equipment generates, uses and can radiate radio part of memory space. frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio Keep a safe distance when using the flash. Do not use the flash on communications. However, there is no guarantee that interference people or animals at close range. Do not cover the flash while taking will not occur in a particular installation. If this equipment does cause a photo. harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is Certification information (SAR) encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. This mobile device meets guidelines for exposure to radio waves as • Increase the separation between the equipment and receiver. set forth by the Federal Communications Commission (FCC). Refer to • Connect the equipment into an outlet on a circuit different from the following. that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC RF Exposure Information HAC notice: Your handset is a radio transmitter and receiver. It is designed and Your phone is compliant with the FCC Hearing Aid Compatibility manufactured not to exceed the emission limits for exposure to radio requirements. frequency (RF) energy set by the Federal Communications The FCC has adopted HAC rules for digital wireless phones. These Commission of the U.S. Government. The guidelines are based on rules require certain phones to be tested and rated under the standards that were developed by independent scientific American National Standard Institute (ANSI) C63.19-2011 hearing aid organization through periodic and thorough evaluation of scientific compatibility standards. The ANSI standard for hearing aid studies. The standards include a substantial safety margin designed compatibility contains two types of ratings: to assure the safety of all persons, regardless of age and health. The exposure standard for wireless handsets employs a unit of • M-Ratings: Rating for less radio frequency interference to enable measurement known as the Specific Absorption Rate, or SAR. The acoustic coupling with hearing aids. SAR limit set by the FCC is 1.6 W/kg. The tests are performed in • T-Ratings: Rating for inductive coupling with hearing aids in positions and locations (e.g. at the ear and worn on the body) as telecoil mode. required by the FCC for each model. The highest SAR value for this Not all phones have been rated. A phone is considered hearing aid model handset as reported to the FCC when tested for use at the ear compatible under FCC rules if it is rated M3 or M4 for acoustic coupling and T3 or T4 for inductive coupling. These ratings are given


Document Created: 2019-02-19 13:05:25
Document Modified: 2019-02-19 13:05:25
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC