Modular approval letter

FCC ID: 2AGRJ-A2RX

Cover Letter(s)

Download: PDF
FCCID_2964568

Intel Corporation 2111 NE 25th Ave Hillsboro, OR 97124 March 17, 2016 Federal Communications Commission, OET Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, Maryland 21046 Northwest EMC TCB 22975 NW Evergreen Pkwy, Suite 400 Hillsboro, OR 97124 Subject: Modular Approval Request Reference: FCC ID: 2AGRJ-A2RX We are seeking a full modular approval for this device being submitted for certification Details as to how the module meets the requirements of FCC Part 15.212 are provided below. 1. “The modular transmitter must have its own RF shielding.” The radio portion of this module has been shielded, please see photographs provided with the application. A can shield covers the top portion of the Bluetooth circuitry and connects into the circuit ground on the board at multiple points around its perimeter. The ground plane on the bottom layer completes the shield to enclose the circuitry. 2. “The modular transmitter must have buffered modulation/data inputs.” The EUT has buffered data Inputs. These are provided by the Texas Instruments CC2541F256RHAT 2.4 GHz Bluetooth® low energy RF System on Chip. 3. “The modular transmitter must have its own power supply regulation.” The module has a Toshiba TCR3DM voltage regulator to provide power to the Bluetooth SoC. The schematic reference is U12. 4. “The modular transmitter must comply with the antenna requirements of section 15.203 and 15.204(C).” The module meets the FCC antenna requirements, the device incorporates a unique antenna connector (MHF-4 micro-coaxial connector) and is provided with an Inverted F antenna, complete with cable and connector to mate to the on-board connector. The antenna is intended to be integrated within the enclosure of the host device. 5. “The modular transmitter must be tested in a stand-alone configuration” The equipment was tested in a stand-alone configuration via a serial cable. Please see section test setup photographs submitted with the application. 6. “The modular transmitter must be labeled with its own FCC ID number.” The module is labelled with its own FCC ID number, please see product label design and the external photograph of the device with this label submitted with the application. 7. “The modular transmitter must comply with any specific rule or operating requirements applicable to the transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements.” The equipment is compliant with all applicable FCC rules. Detailed instructions for maintaining compliance are given in the Regulatory Integration Manual. Page 1 of 2

8. “The modular transmitter must comply with any applicable RF exposure requirements.” The device is compliant with all applicable RF exposure requirements. RF Exposure is addressed in the RF exposure exhibit. If you have any questions please feel free to contact Mark Briggs. Sincerely, Mark Briggs Product Regulatory Engineer Intel Corporation Page 2 of 2


Document Created: 2016-04-04 13:26:21
Document Modified: 2016-04-04 13:26:21
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC