User Manual

FCC ID: 2AG6R-AN510APIAC

Users Manual

Download: PDF
FCCID_4236878

WAVE 2 AC WIRELESS ACCESS POINT Quick Start Guide AN-510-AP-I-AC AN-810-AP-I-AC

Araknis Networks Wireless Access Point Quick Start Guide Federal Communication Commission Interference Statement Industry Canada Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference conditions: in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. (1) This device may not cause interference; and However, there is no guarantee that interference will not occur in a particular installation. If this equipment does (2) This device must accept any interference, including interference that may cause undesired operation of the cause harmful interference to radio or television reception, which can be determined by turning the equipment device. off and on, the user is encouraged to try to correct the interference by one of the following measures: • Reorient or relocate the receiving antenna. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. • Increase the separation between the equipment and receiver. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. d’en compromettre le fonctionnement. • Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance Caution: could void the user’s authority to operate this equipment. (i) The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This interference to co-channel mobile satellite systems; device may not cause harmful interference, and (2) this device must accept any interference received, including (ii) For product available in the USA/Canada market, only channel 1–11 can be operated. Selection of other interference that may cause undesired operation. channels is not possible. This device is designed for indoor use only. Avertissement: IMPORTANT NOTE: FCC Radiation Exposure Statement: (i) Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This mêmes canaux; equipment should be installed and operated with minimum distance 20cm between the radiator & your body. (ii) Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités. In the North American market, only channels 1–11 can be operated. Other channels cannot be selected. Sélection d’autres canaux n’est pas possible. 2 Support: 866.838.5052 © 2016 Araknis Networks® 3

Araknis Networks Wireless Access Point Araknis Networks Wireless Access Point Quick Start Guide Quick Start Guide Industry Canada Statement, Continued CE Statement Radiation Exposure Statement: This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. All operational modes: Déclaration d’exposition aux radiations: 2.4GHz: 802.11b, 802.11g, 802.11n (HT20), 802.11n (HT40), 802.11ac (VHT20), 802.11ac (VHT40) 5GHz: 802.11a, 802.11n (HT20), 802.11n (HT40), 802.11ac (VHT20), 802.11ac (VHT40), 802.11ac (VHT80) Cet équipement est conforme aux limites d’exposition aux rayonnements ISED établies pour un environnement on contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source The frequency and the maximum transmitted power in EU are listed below: de rayonnement et votre corps. AN-510-AP-I-AC AN-810-AP-I-AC 2412-2472MHz: 14.7 dBm 2412-2472MHz: 2.4G: 17dBm Industry Canada Warning 5180-5240MHz: 17.4 dBm 5180-5240MHz: 5G:18dBm This product meets the applicable Innovation, Science and Economic Development Canada technical specifications. The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range.. Ce produit repond aux specifications techniques applicables a l'innovation, Science et Développement economique Canada AT BE BG HR CY CZ DK EE FI FR DE EL HU IE CE Warning IT LV LT LU MT NL PL PT RO SK SI ES SE UK This is a product with CE certification. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. These products are intended to be powered by either PoE/PoE+ or a 12V/2A power supply These products use PoE/+ - IN(48V/0.53A) for both the AN-510-AP-I-AC and AN-810-AP-I-AC. 4 Support: 866.838.5052 © 2016 Araknis Networks® 5

Araknis Networks Wireless Access Point Quick Start Guide Welcome to Araknis Networks™ Step 1: Unbox Thank you for choosing an Araknis™ WAVE 2 AC Wireless Access Point (WAP). With newly designed circular housing, an ingeniously easy new mounting system, convenient PoE power, and the latest WAVE-2 AC wireless technologies, these products are ideal as staples in both residential and commercial applications. . Features • Sleek Circular Design • Unobtrusive recessed lighting • 1 x Gigabit LAN Port (w/802.11af PoE-IN) Wireless Access Point Mounting Bracket Tile Ceiling Backing Plate • 1 x Gigabit LAN Port (as jumper) (WAP)* • Fanless AN-510-AP-I-AC • AN-510-AP-I-AC: 2x2 Dual-Band Wave 2-AC 1300Mbps • AN-810-AP-I-AC: 4x4 Dual-Band Wave 2-AC 2600Mbps • 1 x USB 2.0 • OvrC Enabled with SSID Management! Male-to-Female Tile Ceiling Drywall Wood Surface Jumper Cable Mounting Hardware Mounting Hardware Mounting Hardware (510 has 2 screws) *This manual uses the 810 WAP for illustrative purposes throughout. . AN-810-AP-I-AC 6 Support: 866.838.5052 © 2016 Araknis Networks® 7

Araknis Networks Wireless Access Point Quick Start Guide Step 2: Install Step 3: Connect A Ceiling Mount B Wall Mount C In-Ceiling Mount ENABLED Internet Router PoE Switch WAP POWER + DATA (OUT) AN-ACC-INJ-30W ENABLED DC 48V Input Power DATA (IN) Internet Router Switch PoE Injector WAP (not included) ENABLED NOTE: Use the ceiling backing plate on top of acoustic ceiling tiles to prevent the mounting nuts from pulling through. Internet Router Switch WAP DC Power Supply (not included) 8 Support: 866.838.5052 © 2016 Araknis Networks® 9

Araknis Networks Wireless Access Point Quick Start Guide Step 4: Verify Step 6: Log Into Web Interface LED* A Log in using the default credentials: Username araknis Password araknis B *NOTE: The LED is located on the side of the device. NOTE: If you can’t connect to the WAP using this method, or need to configure the device before connecting it to the network, try these options for accessing your device: LED Status: • DHCP IP address – Page 11 • Blinking: WAP is not working correctly. Refer to the full manual or contact Araknis technical support. • Default IP Address – Page 12 • OvrC – Page 15 • Solid: WAP is operating correctly. 10 Support: 866.838.5052 © 2016 Araknis Networks® 11

Araknis Networks Wireless Access Point Quick Start Guide Pro Tip: Save and Apply Changes Other Access Methods: DHCP IP Address After making changes to settings on a menu page, left-click the “Save” button on the menu to hold the new The WAP is configured to DHCP by default so that the DHCP server can assign an IP address when the WAP is settings in the Apply Changes field. connected to the network (the DHCP server is usually the router). This address can be used for accessing the web interface. Use one of these methods to find the IP address of the WAP: • Check the client table on your router • Use a network scanner (e.g. Fing) to sniff the network. The Araknis WAP manufacturer field will display “Snap AV” After all desired changes have been made, left-click “Apply Changes” to review the new settings. Left-click See the highlighted field in the "Fing" screenshot to the "Apply" to make the changes or "Revert" to cancel the changes. right for an example of an Araknis device being identified. NOTE: Settings will take affect after the progress bar completes 100%. 12 Support: 866.838.5052 © 2016 Araknis Networks® 13

Araknis Networks Wireless Access Point Quick Start Guide Other Access Methods: Default IP Address Other Access Methods: Default IP Address If the WAP is not issued an IP address on the network, or needs to be accessed while not connected to a network, you can configure your computer's network connection to allow access using the default IP address, “192.168.20.253”. Windows 7 screenshots shown for reference. Windows 7 screenshots shown for reference. A Connect your PC to the WAP B On your PC, open the Control C Left-click “Network and Sharing D In the left bar, left-click “Change E Right-click the icon for the F Left-click to highlight “Internet using a network patch cable. Panel and left-click “Network Center”. adapter settings”. wired network connection and Protocol Version 4 (TCP/IPv4), and Internet”. left-click "Properties". then left-click “Properties”. Computer WAP 14 Support: 866.838.5052 © 2016 Araknis Networks® 15

Araknis Networks Wireless Access Point Quick Start Guide Other Access Methods: Default IP Address Other Access Methods: OvrC OvrC gives you remote device management, real-time notifications, and intuitive customer management, right Windows 7 screenshots shown for reference. from your computer or mobile device. Setup is plug-and-play, with no port forwarding or DDNS address required. To add this device to your OvrC account: G In the “General” tab, left-click H Left-click “OK” to close Internet I Open a web browser A Connect the WAP to the Internet "Use the following IP address:" Protocol Version 4 (TCP/IPv4) and navigate to and enter the IP address and Properties, then left-click "OK" “ h t t p : // 1 9 2 .1 6 8 . 2 0 . 2 5 3 / ” . B Log Into OvrC (www.ovrc.com) subnet mask. to close wireless network Log in using the default C Add the Device (MAC address and Service Tag numbers needed for authentication) connection properties. credentials: IP Address 192.168.20.2 Subnet Mask 255.255.255.0 Username araknis Password araknis Web Browser Access 1 2 3 4 5 6 7 8 1 Gbps Link/Act Internet ENABLED AN-110-SW-R-8 Mobile Apps OvrC Server 16 Support: 866.838.5052 © 2016 Araknis Networks® 17

Contacting Technical Support P (866) 838-5052 E techsupport@araknisnetworks.com 2-Year Limited Warranty Araknis Networks® products have a 2-Year Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products that have been abused, modified, or disassembled. Products to be repaired under this warranty must be returned to SnapAV or a designated service center with prior notification and an assigned return authorization (RA) number. US local representative information: Company: Araknis Networks Address: 1800 Continental Blvd. Suite 300, Charlotte, North Carolina, 28273, United States Tel：704-945-7974 Fax: 800.782.2410 © 2019 Araknis Networks® 190305- 1430


Document Created: 2019-03-05 14:28:07
Document Modified: 2019-03-05 14:28:07
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC