User Manual

FCC ID: 2AFSH-CINEVOX-A

Users Manual

Download: PDF



     1
         RESET




EN


     2
EN


                                                                                                      EN
Camera Status                    Status Indicator
Charging when camera is off      Not fully charged - solid red; Fully charged - indicator off
Charging when camera is on       Not fully charged, - solid yellow; Fully charged - solid green
In standby mode (not charging)   Power > 15% - solid green; Power < 15% - solid yellow
MicroSD card not inserted        Flashing blue
Camera error                     Solid red

                                                                                                  3


     4
EN


EN
     5


     6
EN


EN
     7


FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.


This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.


Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.


RF Exposure
To maintain compliance with FCC’s RF Exposure guidelines, this equipment should be
installed and operated with minimum distance of 20cm the radiator your body. This device and
its antenna(s) must not be co-located or operation in conjunction with any other antenna or
transmitter.


Model No.:               CINEVOX/A, CINEVOX
Operation Frequency:     2412MHz~2472MHz for WIFI 2.4G
                         5180MHz~5240MHz for WIFI 5G
                         5745MHz ~ 5825MHz for WIFI 5.8G
Maximum Power:           WIFI 2.4G: 15.30dBm(E.I.R.P)
                         WIFI 5G: 13.80dBm(E.I.R.P)
                         WIFI 5.8G: 6.70dBm(E.I.R.P)


Manufacturer: ShenzhenArashi Vision Company Limited

Address of Manufacturer: 6/F, Building A, Logan Century Center, Haixiu Road, Bao'an District, Shenzhen, China
USB versions 2.0
Receiver category 1
The operating temperature of the device between 0℃ to 45℃.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
The device is going to be operated in 5150 to 5250 MHz frequency range. It is restricted only to indoor use.
This product can be used across EU member states.
We declare that this device is in compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU.



Document Created: 2019-03-12 11:28:15
Document Modified: 2019-03-12 11:28:15

© 2019 FCC.report
This site is not affiliated with or endorsed by the FCC