Users Manual

FCC ID: 2AFP2-FD01

Users Manual

Download: PDF
FCCID_4248271

FD01 中性 3-608FD010690A0001 无线充电器说明书 / 90*65mm 2019.04.12 1:1 128g哑粉纸 双面四色印刷 Connect to Power Adapter Charging Mode Notes Thanks for choosing us! This device complies with Part 18 of the FCC Rules. Power Adapter This is a smart phone wireless charger that allows you enjoy the fun NOTE: This equipment has been tested and found to comply with the of digital products easily. limits for a wireless power charger, pursuant to Part 18 of the FCC Rules. Please kindly read the user manual before using and keep it for These limits are designed to provide reasonable protection against future reference. harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If Dual Wireless Charger this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and User Manual on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product. ① Make sure the wireless charger dock connect to the power supply. ② Put the Qi-enabled smart phone properly on the transmitter, the This equipment complies with FCC radiation exposure limits set forth for Specification indicator light become blue and start charging. The device enter to an uncontrolled environment. This equipment should be installed and ① Connect the power adapter to socket. standby mode when take away the phone from charging pad. operated with minimum distance 20cm between the radiator and your ② Power line is connected with the charging plate. ③ The standby indicator light is green. body. This transmitter must not be co-located or operating in conjunction Input: DC12V,2.5A Charging distance: ≤10mm Note: When Samsung phones which are built-in wireless charging with any other antenna or transmitter. Frequency: 110~205KHZ Conversion: ≥72% function get fully charged with this product, if don't move the phone in a long time, the battery power keeps in fully charged status(supplementary Dimensions: 200×90×10mm NW.: 125g charge). 感谢您购买本产品! 连接适配器充电 手机正确充电方式 注意事项 本产品是一款智能手机无线充电器，能让您轻松体验数码产品的无限 1、请勿挤压或碰撞。 乐趣。 USB适配器 2、请勿自行拆卸或投入火中、水中，避免造成短路漏电。 使用本产品前请认真阅读本手册并妥善保存，以备查阅。 3、请勿在严重高温、潮湿或腐蚀性环境下使用无线充电器，避免损 坏电路出现漏电现象。 4、请勿与带磁条或者芯片的磁卡（身份证、银行卡等）放置太近， 避免造成磁卡失效。 5、请保持植入医疗设备（心脏起搏器、植入性耳蜗等）与无线充电 双座无线充电器 器之间的距离至少为20cm，以避免对医疗设备造成潜在干扰。 6、应看管好儿童，以确保他们不将无线充电器当成玩具来玩，以避 免不必要的意外。 用户手册 ① 确认无线充电器连接电源，并处于待机状态。 规格参数 ② 将带有无线充电功能的手机正确放置在发射板上，指示灯显示为蓝 ① 将电源适配器插在插座上。 色，无线充电器处于充电状态。当移除手机，无线充电器进入待机模 ② 电源线连接充电板。 式。 输入电压：DC12V,2.5A 接收距离：≤10mm ③ 充电板待机时指示灯显示绿色。 工作频率：110~205KHz 电力转换：≥72% 注：使用该产品为三星自带无线充功能的手机充电时，当手机充满后，若手机长时 说明书涉及图片均为示意图，最终产品以实物为准。 规格尺寸：200×90×10mm 产品重量：125g 间未拿开，该手机将保持电量在 100% 状态（补充充电） 。 内含：无线充电器、电源适配器、产品说明书。


Document Created: 2019-04-12 10:10:28
Document Modified: 2019-04-12 10:10:28
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC