DSS REPORT 2

FCC ID: 2AFHW-VWM100

Test Report

Download: PDF

FCCID_4401402

Report No.: TCT190627E013

6.9. Conducted Band Edge Measurement
6.9.1. Test Specification

Test Requirement: FCC Part15 C Section 15.247 (d)
Test Method: KDB 558074 D01 v05r02
In any 100 kHz bandwidth outside the intentional
radiation frequency band, the radio frequency power
shall be at least 20 dB below the highest level of the
Limit:
radiated power. In addition, radiated emissions which fall
in the restricted bands must also comply with the
radiated emission limits.

Test Setup:

Test Mode: Transmitting mode with modulation
1. Set to the maximum power setting and enable the
EUT transmit continuously.
2. Set RBW = 100 kHz (≥1% span=10MHz), VBW = 300
kHz (≥RBW). Band edge emissions must be at least
20 dB down from the highest emission level within
the authorized band as measured with a 100kHz
Test Procedure:
RBW. The attenuation shall be 30 dB instead of 20
dB when RMS conducted output power procedure is
used.
3. Enable hopping function of the EUT and then repeat
step 2 and 3.
4. Measure and record the results in the test report.
Test Result: PASS

6.9.2. Test Instruments

Equipment Manufacturer Model Serial Number Calibration Due
Spectrum Analyzer Agilent N9020A MY49100619 Sep. 20, 2019
RF Cable
TCT RE-06 N/A Sep. 20, 2019
(9KHz-26.5GHz)
Antenna Connector TCT RFC-01 N/A Sep. 20, 2019
Note: The calibration interval of the above test instruments is 12 months and the calibrations are traceable to
international system unit (SI).

Page 36 of 60

Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com

Document Created: 2019-08-23 21:38:46
Document Modified: 2019-08-23 21:38:46

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC