Operation Description

FCC ID: 2AFEJ-HWT19A

Operational Description

Download: PDF
FCCID_4433081

                              Operation Description
                                 FCC ID:2AFEJ-HWT19A
                                  Model Name:Q11K V2
The device under test is an active electromagnetic wireless pen tablet.
The system includes: the main control MCU, the antenna to receive electromagnetic pen
signal, electromagnetic pen, operational amplifier, wireless transmitter module RF,
wireless receiver module RF . The system is powered by a rechargeable lithium-ion
battery with a nominal voltage of 3.7V.

Pen Tabletworking process: the tablet antenna receive electromagnetic signals emitted by
electromagnetic pen, and get the corresponding coordinate of the electromagnetic pen
after the operational amplifier and main chip processed the signals. The data after
processing will be sent to wireless transmitter module RF by the host MCU via the main
serial circuit. Then the receiving module receives the data of the wireless transmitting
module and reports it to the device to form the drawing or handwriting.

Wireless transmitter module and receiver module are used RF, standard private 2.4G,
frequency band 2.4G-2.5G, but the transmitter module only have the transmitter function
and the receiver module only have receive function; and it's no need to match the
trasmitting and revieving frequency by hand. The crystal of the wireless module all adopts
the external crystal of 16MHZ.

Wireless connection operation mode:
Register set modulation by GFSK, data transfer rate of 1Mbps, 250KHz deviation, the
number of channels in the factory according to the serial number of the number of
channels to choose, can not be frequency hopping.In addition to the board only to launch,
Dongle only to receive, Dongle channel and synchronous word information in the factory
configuration and the board, they are one to one.

The features of the control chip MCU are as follows:
With full-speed USB2.0 function,Built-in Cortex ™ -M0 core,running up to 50 MHz, built-in
32K / 64K / 128K bytes of Flash memory, and 4K / 8K / 16K bytes of built-in SRAM, 4K
bytes for the storage ISP boot code ROM, and 4 Kbytes of data flash memory. There is
also a wealth of peripherals, such as timers, watchdog timer, RTC, PDMA, UART, SPI, I2C,
I2S, PWM timer, GPIO, PS / 2, USB 2.0 FS device 12 ADC, Analog Comparator,
low-voltage reset control and under-voltage detection.
 The EUT is a Creative Pen Tablet
Operating frequency: 2406~2476MHz
Modulation: GFSK
Antenna Designation: PCB Antenna
Antenna Gain (dBi):0dBi
Hardware version number: REV03
Software version number: 180709



Document Created: 2019-09-06 11:42:08
Document Modified: 2019-09-06 11:42:08

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC