User Manual

FCC ID: 2AE6GUHF-6200-R2

Users Manual

Download: PDF
FCCID_4105971

UHF-6200 WIRELESS RECEIVER 81 2 7 3 4 5 6 3 4 5 7 8 Front 9 10 11 12 9 Rear Parts Description 1. On/Off switch: Turn on/off the receiver. 2. Infrared (IR) port: Broadcasts IR signal to transmitter to synchronize frequencies. 3. Menu switch: Press to scroll through menu options. 4. Select switch: Press to select the currently displayed menu option. 5. Sync Button: Press to initiate IR connection between receiver and transmitter. 6. LCD display: display group, channel no, RF and AF level. 7. Volume control: Turn to adjust volume. 8. Antenna connector: To install supplied antenna here. 9. Individual Balanced XLR output 10. Mixed 1 / 4 " output jack 11. MIC/LINE switch 12. DC input jack Specifications Frequency Range: 512~537.5MHz Frequency Stability: 10ppm Sensitivity: 13dBuV Adjacent channel rejection：75dB Image rejection: 95dB Audio Output：200MV Output Impedance: XLR connector: 200 ; 1 / 4 inch connector: 1k S/N ratio: 100dB Total Harmonic Distortion: < 0.1% Frequency response: 50Hz-15KHz Operating Range :60m( in line and sight area) Power supply: DC12V/500mA

Receiver Programming Note: Transmitting devices such as cellular phones and two-way radios may interfere with wireless audio transmissions. Keep your transmitters and receivers away from these and other potential sources of interference. 1. Turn on receiver. LCD will light. 2. Channel A set up Group Selection a. Press CH-A “MENU” button to move cursor to “GROUP SELECT”. b. Press CH-A “SELECT” button to increase the group number by one. c. When the correct group is displayed, either wait five seconds for the screen to time out, or press CH-A “SYNC” button. Channel Selection a. Press CH-A “MENU” button again to move cursor to “CHANNEL SELECT” . b. Then press CH-A “SELECT” button to increase the channel number by one. c. When the correct channel is displayed, either wait five seconds for the screen to time out, or press CH-A “SYNC” button. 3. Channel B set up Follow the same steps as described in step 2, press CH-B buttons to set up Channel B. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.


Document Created: 2018-11-07 11:04:13
Document Modified: 2018-11-07 11:04:13
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC