User Manual

FCC ID: 2ADX3-M50L

Users Manual

Download: PDF

FCCID_4060059

FCC Warning:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
üReorient or relocate the receiving antenna.
üIncrease the separation between the equipment and receiver.
üConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
üConsult the dealer or an experienced radio/TV technician for help.

SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well below the maximum value, in general, the closer you are to a
wireless base station antenna, the lower the power output.
Before a new device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the
exposure limit established by the FCC, Tests for each device are performed in positions and locations as required by the
FCC.

For body worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an
accessory designated for this product or when used with an accessory that contains no metal and that positions the handset a
minimum of 10 mm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.

Document Created: 2019-03-23 15:45:21
Document Modified: 2019-03-23 15:45:21

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC