Modular Approval Attestation

FCC ID: 2ADHKATWINC1500

Attestation Statements

Download: PDF
FCCID_2783012

Atmel September 25, 2015 Request for a modular approval Dear Application Examiner, The Atmel U.S. module Model: ATWINC1500 is seeking FCC authorization as a modular transmitter. The requirements of FCC 15.212 are met. The following requirements are fulfilled: 1. The modular transmitter must have its own RF shieldirl\g The radio portion of the module is contained under its own RF shield; please refer to the module photos. 2. The modular transmitter must have buffered modulation/data inputs The modular transmitter has it‘s own data buffer. Transmit data is stored in imbedded memory and shifted out to the modulator which provides several buffering stages between incoming data and the modulator. 3. The modular transmitter must have its own power supply regulation The Modular Transmitter has it‘s own supply regulation implemented with dedicated LDOs and DC/DC power converter. 4. The modular transmitter must comply with the antenna requirements of Section 15.203 The antenna is permanently attached (printed) on,each module. 5. The modular transmitter must be tested in a stand—alone configuration The EUT was tested in a stand—alone configuration. A motherboard which supplied power to the module and connectors for control signals was attached to the module with wires. The module and the motherboard were separated by 10cm. 6. The modular transmitter must be labeled with its own FCC ID number The EUT will be labeled with its own FCC ID number. The User Manual instructs OEM customers on how to place an exterior label in case it is not visible. 7. The modular transmitter must comply with any specific rule or operating requirements applicable to the transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. The EUT is compliant with all applicable FCC rules. Detailed instructions are given in the User‘s Guide. 8. The modular transmitter must comply with any applicable RF exposure requirements in its final configuration. Instructions are given in the installation manual for compliance to the RF exposure requirements. Sincerely, Hassan Hashemi Senior Director, Operations & Advanced Packaging Atmel Corporation 1 Spectrum Pointe Drive T: (949) 340.6150 Suite 225 F: (949) 707.4027 Lake Forest, CA 92630 www.atmel.com


Document Created: 2015-09-25 10:01:43
Document Modified: 2015-09-25 10:01:43
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC