Users Manual

FCC ID: 2ABYU-RBT003

Users Manual

Download: PDF
FCCID_3822397

                                          User Manual
                RadBeacon Locator Tent                              Model: RBT-003
Bluetooth Smart 5.0 proximity beacon powered by 1 CR2477 Lithium battery with tent
form factor for extended battery life and a waterproof enclosure.

The idea is to redesign the electronics to use a larger battery.

The tent beacon has an accelerometer to extend battery life by trigger on accelerometer event.

The tent enclosure should be really waterproof to allow the tents to be washed in the restaurant.


 Category          Requirement                 Additional Detail                     Partner Comments

 Bluetooth         Bluetooth Low Energy v5.0   Advertising Extensions, GATT
                                               Services, L2CAP Channels

 Microprocessor    ARM Cortex M4               This is based on the Nordic
                                               NRF52832 SOC as a likely
                                               candidate architecture. Open to
                                               alternatives

 Flash             512kB of flash memory       This is based on the Nordic
                                               NRF52832 SOC as a likely
                                               candidate architecture. Open to
                                               alternatives

 RAM               64kB RAM                    This is based on the Nordic
                                               NRF52832 SOC as a likely
                                               candidate architecture. Open to
                                               alternatives

 Range             100m at max tx power        This is based on the Nordic
                                               NRF52832 SOC as a likely
                                               candidate architecture. Open to
                                               alternatives

 Antenna           Trace or Chip,
                   Omnidirectional

 Sensor            Accelerometer               Motion and fall detection triggered

 Power Source      1 x CR2477                  1 x 1,000 mAh

 Battery Life      12 Months                   Based on 100Hz advertising rate at
                                               +3dBm TX Power

 Enclosure         IP67 Rated

 Enclosure         UL 94 V-0 Flame Rated

 Firmware          Multiple interleaved        iBeacon, AltBeacon, AltBeacon
                   advertisements              TLM, Eddystone UID, Eddystone
                                               URL, Eddystone TLM, Eddystone
                                               EID, Eddystone ETLM


Tent Notional Layout / Form Factor


IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject
to the following two conditions:
        (1) This device may not cause interference; and
        (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The term “IC: “ before the certification/registration number only signifies that the Industry
Canada technical specifications were met. This product meets the applicable Industry
Canada technical specifications.

Le présent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation



Document Created: 2018-04-03 15:14:30
Document Modified: 2018-04-03 15:14:30

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC