User manual

FCC ID: 2ABY9-GRAVITY-2

Users Manual

Download: PDF

FCCID_4392188

GRAVITY 2 10W Wireless Charging Power Bank
GRAVITY 2
Manual

1. Product function
1.1 Instruction of wireless charging function

The product could achieve short-range radio transmission by magnetic induction,
applicable to charging for digital products of 5V or 9V.Communications, furniture, fire
protection ,water proof and other digital products, this product meets Qi wireless charging
standard. It could be wireless charging with all the Qi standard receiver.

1.2 It can make sure 100% charging precision
Put the phone with wireless charging function on the GRAVITY 2 transmitter correctly, the
phone will be wireless charging.
Wireless Output voltage: DC5V 1A or DC9V 1.1A

1.3 USB input function
GRAVITY 2 can wireless charging by connect to safety adapter or Micro USB wire connect
to computer:
Micro-B Input voltage: DC5V 2.1A or DC9V 2A
USB-C Input voltage: DC5V 2.5A or DC9V 2A
USB-A Output voltage: DC 5V 2.4A or DC9V 2A or 12V 1.5A
USB-c Output voltage: DC 5V 3A or DC9V 2A or 12V 1.5A

1.3 Transmitter pad indicator light working description
Power on: After 2 seconds of green and blue indicator light flash alternately. indicator light
will be turn green for a long time then enter into standby mode.
Standby: Indicator light will be turn green for a long time
Charging: Indicator light will be turn blue for a long time, remove the receiver, the indicator
light will turn green, enter into standby mode.

2. Automatic protection function
When the transmitter detected its connector’s load current is too large (current
exceeds the rated output), the transmitter will shut off with the mobile receiver connection
automatically, safety protection automatically. Put the mobile phone in correct position
again after move the mobile 5 seconds later. It will re-enter charging status when the
connection is successful.

FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.

RF Exposure: A distance of 15 cm shall be maintained between the antenna and users, and the transmitter may not be co-located with
any other transmitter or antenna.

Document Created: 2019-08-06 17:29:48
Document Modified: 2019-08-06 17:29:48

© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC