Modular Approval Request Letter_BDE Rev03

FCC ID: 2ABRUBDLEM201P

Cover Letter(s)

Download: PDF
FCCID_2446305

BDE Technology Co., Ltd. Modular Approval Request Letter FCC ID: 2ABRUBDLEM201P Data: 11.11.2014 Gentlemen: There’s an Bluetooth 4.0 single mode module that would like to have your authorization as a modular approval. The specific product as below, Bluetooth 4.0 single mode module, with its designed features and specified description, meets special requirements for full modular approval on FCC Public Notice KDB996369 Released: June 26, 2000 by cross-reference list below. Company BDE Technology Co., Ltd. Model Name Bluetooth 4.0 single mode module Model Number BDE-BLEM201P FCC ID 2ABRUBDLEM201P Requirement of Public Notice KDB996369 / part 15.212 N/A 1. The modular transmitter must have its own RF shielding. The module has its own RF shielding. Please see external photo.pdf 2. The modular transmitter must have buffered modulation/data inputs. The modular has buffered data inputs, it is integrated in chip CC2541. Please see datasheet of the RF IC, CC2541 for detail. 3. The modular transmitter must have its own power supply regulation. The RFIC, CC2541, has its own power supply regulation. Please see datasheet of RFIC CC241 for detail 4. The modular transmitter must comply with the antenna The BDE-BLEM201P has its own integral antenna on board and meets the FCC requirements of Section 15.203 and 15.204(c). antenna requirements. Please see external photo.pdf 5. The modular transmitter must be tested in a stand‐alone The BDE-BLEM201P was tested in a stand‐alone configuration via a CC debugger. configuration, i.e., the module must not be inside another device Please see conducted set‐up photo.pdf and spurious set‐up during testing. 6. The modular transmitter must be labeled with its own FCC ID The label position of BDE-BLEM201P is clearly indicated. Please see the label.pdf number, and, if the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.

7. The modular transmitter must comply with any specific rule or The BDE-BLEM201P is compliant with all applicable FCC rules. Detail instructions operating requirements applicable to the transmitter and the are given in the Users Manual. Please see Installation guide.pdf manufacturer must provide adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. 8. The modular transmitter must comply with any applicable RF The BDE-BLEM201P comply with applicable RF exposure requirements. Please exposure requirements. For example, FCC Rules in Sections 2.1091, see RF safety evaluation. pdf 2.1093 and specific Sections of Part 15, including 15.319(i), 15.407(f), 15.253(f) and 15.255(g), require that Unlicensed PCS, UNII and millimeter wave devices perform routine environmental evaluation for RF Exposure to demonstrate compliance. In addition spread spectrum transmitters operating under Section 15.247 are required to address RF Exposure compliance in accordance with Section 15.247(b)(4). Thank you. Sincerely,


Document Created: 2014-11-18 00:13:31
Document Modified: 2014-11-18 00:13:31
© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC