Regulatory Flyer

FCC ID: 2AB8ZND1

Users Manual

Download: PDF
FCCID_2368898

IMPORTANT REGU ORY INFORMATION FCC Statement (USA) ICES—003 (Canada) This device complies with Part 15 of the FCC Rules. Operation is subject to This digital apparatus does not exceed the Class B limits for radio the following two conditions: noise emissions from digital apparatus set out in the interfer= + This device may not cause harmfulinterference ence—causing equipment standard entitled: "Digital Apparatus," + This device must accept anyinterference received including 1ICES—003 of the Canadian Department of Communications. interference that may cause undesired operation. Cet appareil numérique respecte les limites bruits radioélectriques This equipment has beentested and found to comply with the limits for a applicables aux appareils numériques de Classe Bprescrites dans la Class B digital device, pursuant to part 15 of the FCC Rules. These limits are norme sur le matérie! brouilleur: "Appareils Numériques®, NMB—003 designed to provide reasonable protection against harmful interference in édictee par le Ministre Canadian des Communications. a residential installation. This equipment generates, uses and can radiate This device has Bluetooth and WiFi capabilties; the device complies radio frequency energy and, if not installed and used in accordance with with Indlustry Canada license—exempt RSS standard(s). Operationis the instructions, may cause harmfulinterference to radio communications. subject to the following two conditions;(1) this device may not cause However, there is no guarantee that interference will not occur in a interference, and (2) this device must accept any interference, particularinstallation.If this equipment does cause harmfulinterference to including interference that may cause undesired operation of the radio or television reception, which can be determined by tuning the device. equipment off and on, the user is encouraged to try to correct the Cet appareil est équipé de capacités Bluetooth et Wi—Fi; l est con— interference by one or more of the following measures: forme aux normes CNR c‘industrie Canada d‘exemption de licence. + Reorient or relocate the receiving antenna. Son fonctionnementest soumis aux deux conditions suivantes: 1) + Increase the separation between the equipment and receiver. cet appareil ne provogue pas dinterf¢rences nuisibles et 2) cet ap— + Connect the equipmentinto an outlet on a circuit ifferent from that pareil doit absorber les interférences qu‘l regoit,y compris celles qui to which the receiver is connected. peuvent provoguer un fonctionnement inopiné. + Consult the dealer or an experienced radio/TV technician for help. WARNING! Exposure to Rado Frequency Radiation The radiated Europe (CE Dect; on of Conformity) output power of this device is below the FCC and Industry Canada radio EXPOSURE TO RADIO FREQUENCY RADIATION. frequency exposure limits. &mm separation rom bodis reguired. This device must not be co—located or operating in conjunction with any The exposure standard employs a unit of measurement known as the Specific Absorption Rate (SAR). The SAR was obtained by other antenna or transmitter. testing the device at standard operating positions with the CAUTION: When using IEEE 802.11a wireless LAN, this product is device transmitting at its highest certified power level in all restricted to indoor use, due to ts operation in the 5.15— to 5.25—GHz tested frequency bands. The actual SAR of the device while oper— frequency range. The FCC requires this product to be used indoors for ating can be well below the maximum value, because the device the frequency range of 5.15 GHz to 5.25 GHz to reduce the potential operates at multiple power levels and uses only the power re— for harmfulinterference to co—channel mobile satellite systems. quired to reach the network. High—power radar is allocated as the primary user of the 5.25— to This product complies with the Low Voltage Directive 5.35—GHz and 5.65— to 5.85—Ghiz bands. These radar stations can 2006/95/EC; EMC Directive 2004/108/EC, EU Directive R&TTE cause interference with and/or damage to this device. Directive 1999/5/EC, and RoHS Directive 2011/65/EU. Point of contact: Intel Corporation, Attn: Corporate Quality, 200 Mission College Blvd., Santa Clara, CA 05054 USA ProductEcology@ intel.com ( € H47948—001


Document Created: 0160-06-22 00:00:00
Document Modified: 0160-06-22 00:00:00
© 2025 FCC.report
This site is not affiliated with or endorsed by the FCC