Supporting Statement

0798-EX-ST-2015 Text Documents

Southwest Research Institute

2015-07-28ELS_165208

                                                        Southwest Research Institute
                                                                  Application for STA
                                                            File No. 0798-EX-ST-2015

                        SUPPORTING STATEMENT
             FOR REQUEST FOR SPECIAL TEMPORARY AUTHORITY

Pursuant to Section 5.3(a), (f) and (j) and Section 5.61 of the Federal Communications
Commission (“FCC”) rules, 47 C.F.R. §§ 5.3(a), (f), (j) and 5.61 (2013), Southwest
Research Institute (“SwRI”) respectfully requests special temporary authority (“STA”)
commencing September 1, 2015, to evaluate the performance characteristics of
narrowband, frequency hopping transmissions in selected HF bands below 25 MHz.

In support of SwRI’s request, the following is shown:

1)    Applicant’s Address, Background and FRN:

      Southwest Research Institute is headquartered at 6220 Culebra Road, San
      Antonio, TX 78238-5166. It is an independent, not-for-profit, applied engineering
      and development organization devoted to technology development and transfer.
      It conducts business with the industry and government (U.S. and other friendly
      nations) on a worldwide basis. Approximately 50% of the SwRI’s business is for
      the U.S. Government. Its FCC Registration Number (“FRN”) is 0004074217.

2)    Need for STA:

      SwRI seeks to conduct a limited set of tests for several days during the period
      September 1, 2015 through February 28, 2016, to obtain real-world data samples
      of the characteristics of narrowband, frequency hopping HF transmissions. The
      results of the tests will be used to determine the need for continued research and
      development in this area. Experimental authority is required to conduct such
      tests, and a six-month STA term will provide SwRI flexibility for scheduling the
      actual test dates.

3)    Purpose and Description of Operation:

      As noted above, the experimental authority requested herein will allow SwRI to
      the test the performance characteristics of narrowband, frequency hopping HF
      transmissions. This evaluation will include an assessment of the propagation
      and functionality of such transmissions and their ability to communicate under
      varying conditions. Specifically, SwRI seeks to obtain real-world data samples of
      the characteristics of narrowband, frequency hopping HF transmission
      techniques for both single channel detection, angle of arrival, and time
      differences of arrival (“TDOA”) across these bands..

4)    Dates of Proposed Operation:

       September 1, 2015, through February 28, 2016


                                            1


5)   Location(s) of Proposed Operations:

     The tests will be conducted within the campus of Southwest Research Institute,
     6220 Culebra Road, San Antonio (Bexar County), Texas. Operations will be at
     temporary fixed locations within a 1 km radius of NL 29-26-29; WL 98-37-56
     (NAD 83). SwRI’s campus is comprised of approximately 1200 acres, and the
     location of the test transmitter antenna would be near the center of the campus.
     The nearest off-campus property is over 800 meters away.

6)   Class of Station:

     The FCC station class code for the proposed operation is “FX.” A limited number
     of mobile units may be located at temporarily fixed locations on the campus as
     described above.

7)   Equipment To Be Used:

     SwRI proposes to operate a single fixed base station capable of operating in the
     requested bands. Specifically, it proposes to deploy an Agilent E4438C Agile
     Signal Generator with RF output levels in the range of -40 dBm to 13 dBm
     feeding a vertically oriented 3 meter long monopole at a location 1.4 km from
     from the array center. SwRI will use a receive antenna with an 8-element
     circularly disposed antenna array of eight 6.5 meter Tilted Folded quad-summed
     Dipoles (TURNSTILES) with a radius of 40 meters.

8)   Frequencies Desired:

     As stated in Section 3, SwRI seeks to obtain real-world data samples of the
     characteristics of frequency hopping transmissions in the HF spectrum. Thus, it
     is critical to SwRI to conduct tests in several HF bands with a range of signal to
     noise ratios (“SNRs”). Specifically, SwRI proposes to operate in the HF bands in
     selected HF bands between 6.2 MHz and 22.8 MHz specified in Attachment A. It
     does not propose, however, operating on channel centers deployed by licensees
     in the public safety (radio service code “PW”), aeronautical fixed (“AF”) or public
     coast (“PC”) radio services. Company personnel will also monitor the operations
     of other users before commencing transmissions to avoid interference to such
     users.

     SwRI also recognizes that the use of certain frequencies will require coordination
     through the Interdepartment Radio Advisory Committee (“IRAC”) and SwRI is
     amendable to deleting certain frequencies from the bands requested and
     coordinating with Federal government personnel prior to commencing any
     transmissions.




                                          2


9)    Power Level:

      SwRI will operate with the minimum necessary power to conduct its test, and in
      no event will that level exceed a peak of 1 Watt Effective Radiated Power
      (“ERP”).

10)   Type of Emission, Modulation Technique, and Bandwidth Required:

      SwRI proposes to use computer-generated pseudorandom bit streams of data
      files generated in Matlab, and these bit streams will be modulated using
      narrowband (2,4,8 level) FSK and PSK techniques with baud rates between 100
      and 2400 baud with bandwidths limited to 3.2 kHz or less. The narrowband
      signal will be divided into appropriate duration dwells to match 5, 10, 20, and 30
      hops per second and modulated onto carriers spanning 100 kHz, 200 kHz, and
      300 kHz bandwidths with channel spacing of 1 kHz.

      The primary emission designator for such operations is 3K20D1D, as indicated
      on the accompanying FCC Form. Other emission modes and modulation
      techniques may be utilized, but in no event will the emissions extend beyond the
      limits associated with the above-referenced emission. SWRI does not propose
      to supply station identification as set forth in Section 5.115 of the Commission's
      Rules.

11)   Overall Height of Antenna(s) Above Ground:

      SwRI will comply with all Federal Aviation Administration (“FAA”) and FCC rules
      and regulations regarding the installation and operation of antennas and their
      support structures. The antennas to be deployed under this authority will not
      extend more than six meters above the ground or, if mounted on an existing
      building or tower, will not extend more than six meters above the building or
      above the FAA/FCC approved height for a tower or building.

12)   Restrictions on Operation

      SwRI expects that the durations of any single HF transmission will range
      between 5 and 10 seconds. The duty cycle on each dwell will be constant within
      any single transmission, but will be varied between subsequent transmissions to
      range between 50 and 100%. The sequence of hopping channels will be
      computer generated pseudorandom, but controlled to ensure minimal reuse of
      any single channel during a transmission. At least one minute will elapse
      between any successive transmissions.

      SwRI anticipates that the initial transmissions will be performed within one 8 hour
      period. An analysis to assess the quality of collection will require at least one
      day and, if necessary, SwRI may need to re-conduct certain portions of the test.
      Thus, the likely duration of all tests is expected to be less than 16 hours. SwRI
      has requested an STA for a six month term, however, to accommodate the fact



                                           3


      that it does not currently know exactly when those tests will be conducted within
      that period.

      Moreover, SwRI does not propose to market, sell, or lease unapproved
      equipment to end users or conduct a market study in conjunction with this test.
      After the completion of the tests, SwRI will recall and recover all devices that do
      not comply with FCC regulations. If any different treatment becomes necessary
      during the course of its experimentation, SwRI will seek separate and additional
      authority from the agency.

      Last, SwRI understands that: (a) permission to operate the units has been
      granted under experimental authority issued by the Federal Communications
      Commission, is strictly temporary, and may be cancelled at any time and that (b)
      operation is subject to the condition that it not cause harmful interference.

13)   Interference Protection/Stop Buzzer Contact Information:

      SwRI understands that other stations may be licensed in the bands it has
      requested and that, if any interference occurs, it may be required to discontinue
      its operations immediately. It does not expect interference to occur, however, as
      its tests will be conducted only on a limited basis as described above. Moreover,
      SwRI personnel will be monitoring the RF spectrum and will carefully select
      areas of the HF spectrum to minimize any interference with observable
      transmissions.

      As discussed earlier, SwRI recognizes that his request will need to be
      coordinated by the Commission through the IRAC, and SwRI is amendable to
      deleting certain frequencies from the bands requested and coordinating with
      Federal government personnel prior to commencing any transmissions.

      In that regard, SwRI advises the Commission that John Tinsley, Staff Scientist, is
      the technical contact overseeing these tests. He will be personally responsible
      for the operations and will serve as the “stop buzzer” in the event that operations
      must be terminated because of any interference concerns. Mr. Tinsley can be
      reached at (210) 522-6285, email: john.tinsley@swri.org.

14)   Compliance With Human Exposure Limits:

      SwRI certifies that it will operate under this STA in full compliance with IEEE
      C95.1 - 1991, "IEEE Standard for Safety Levels with Respect to Human
      Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.” All
      personnel who will operate the equipment are knowledgeable as to the effects of
      RF energy and will have the ability to control their exposure.




                                           4


15)   Application Contact Information:

       Company Contact:                      “Stop Buzzer” Contact:

       Monica R. Trollinger                  John Tinsley
       Deputy General Counsel                Staff Scientist
       6220 Culebra Road                     6220 Culebra Road
       San Antonio, TX 78238-5166            San Antonio, TX 78238-5166
       Telephone: (210) 522-6024             Telephone: (210) 522-6285
       Facsimile: (210) 522-5839             john.tinsley@swri.org
       mtrollinger@swri.org



       Legal Contacts:

       David E. Hilliard
       Kurt E. DeSoto
       Wiley Rein LLP
       1776 K Street, N.W.
       Washington, DC 20006
       Telephone: (202) 719-7000
       Facsimile: (202) 719-7207
       Email: dhilliard@wileyrein.com
       Email: kdesoto@wileyrein.com




                                         5


                                    ATTACHMENT A

                             Proposed Bands of Operation

Although frequency bands are specified below, SwRI proposes to operate on
frequencies with a 3.2 kHz bandwidth as described in the supporting statement.
SwRI would agree to special conditions on the face of the grant of authority that limit
operations to certain frequencies or that restrict the use of certain frequencies or sub-
bands.

                                      6.2 – 6.5 MHz
                                     10.2 – 11.7 MHz
                                     16.4 – 17.4 MHz
                                     22.0 – 22.8 MHz




                                             6



Document Created: 2015-07-28 11:29:01
Document Modified: 2015-07-28 11:29:01

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC