R7PEG1R1S7

FCC ID

Equipment: LTE-M Cellular Communication Module

Landis+Gyr Technology, Inc. EG1R1S7

30000 Mill Creek Avenue, Suite 100, Alpharetta, GA 30022 United States

Application
Frequency Range
Final Action Date
Granted
Ol04lqSrIG+dpSBp7XHoyw==
2405.0-2475.0
2020-05-21
APPROVED
File NameDocument TypeDateDirect
RF ExposureRF Exposure Info 2020-05-21 00:00:00 pdf
Test ReportTest Report 2020-05-21 00:00:00 pdf
Test Setup PhotosTest Setup Photos 2020-05-21 00:00:00 pdf
ManualUsers Manual 2020-05-21 00:00:00 pdf
Label InformationID Label/Location Info 2020-05-21 00:00:00 pdf
Internal PhotosInternal Photos 2020-05-21 00:00:00 pdf
Modular Approval LetterCover Letter(s) 2020-05-21 00:00:00 pdf
Confidentiality RequestCover Letter(s) 2020-05-21 00:00:00 pdf
Agency Agreement LetterCover Letter(s) 2020-05-21 00:00:00 pdf
External PhotosExternal Photos 2020-05-21 00:00:00 pdf
Block DiagramBlock Diagram N/A
Theory of OperationOperational Description N/A
SchematicsSchematics N/A

Application Details:

EquipmentLTE-M Cellular Communication Module
FRN0011025368
Grantee CodeR7P
Product CodeEG1R1S7
Applicant BusinessLandis+Gyr Technology, Inc.
Business Address30000 Mill Creek Avenue, Suite 100 , Alpharetta,Georgia United States 30022
TCB ScopeA4: UNII devices & low power transmitters using spread spectrum techniques
TCB Email[email protected]
ApplicantJames L Stortz – Director of Hardware Engineering
Applicant Phone
Applicant Fax678-258-1550
Applicant Email[email protected]
Applicant MailStop
Test FirmTUV SUD America, Inc.
Test Firm ContactWilliam Elliott
Test Firm Phone
Test Firm Fax
Test Firm Email[email protected]
Certified ByMarlene Sealey – Certification Coordinator
Comment [Ol04lqSrIG+dpSBp7XHoyw==]: Modular Approval. Power listed is Conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end-user has no manual instructions to remove or install the device. Installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. Output power must be reduced to 17mW when transmitting on 2475MHz. Device must transmit with a source-based, time-averaged duty cycle not to exceed 39.16% controlled via software or firmware. Device is co-located with FCC ID: N7NHL78M.

© 2020 FCC.report
This site is not affiliated with or endorsed by the FCC