|Applicant Business||Hangzhou Tuya Information Technology Co.,Ltd|
|Business Address||Room701,Building3,More Center,No.87 GuDun Road, , Hangzhou,Zhejiang,N/A China |
|TCB Scope||A4: UNII devices & low power transmitters using spread spectrum techniques|
|TCB Email||[email protected]|
|Applicant||xiaodong Shou – General Manager |
|Applicant Phone|| |
|Applicant Email||[email protected]|
|Test Firm||Intertek Testing Services Shanghai|
|Test Firm Contact||Leah Xu|
|Test Firm Phone|| |
|Test Firm Fax|
|Test Firm Email||[email protected]|
|Certified By||Erick Liu – Certification Engineer|
Comment [dM+vv3z4dd28lDk5VLHA3Q==]: Power Output listed is Conducted. Modular Approval. This device is granted for use in Mobile only configurations in which the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and not be co-located with any other transmitters except in accordance with FCC multi-transmitter product procedures. Only those antenna(s) tested with the device or similar antenna(s) with equal or lesser gain may be used with this transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. The Grantee is responsible for providing the documentation required for modular use. The responsibility for the use of this module, in all configurations utilized or contemplated, remains with the Grantee.
This device has a 20 MHz and 40 MHz bandwidth mode.
Comment [h0UqLbUYeembVvh7Iv38og==]: Modular Approval. Output power listed is conducted. This transmitter is approved for use in mobile RF exposure category configurations with the antenna(s) installed to provide a separation distance of at least 20 cm from all persons. This grant is valid only when the module is sold to OEM or OEM integrator. Co-location of this module with other transmitters that operate simultaneously is required to be evaluated using the FCC multi-transmitter procedures. The integrator must be provided with specific information required to satisfy RF exposure compliance for final host devices and installations. Compliance of this device in all final host configurations is the responsibility of the Grantee. Installation of this device into portable RF Exposure category host devices requires the submission of a Class II permissive change or new application. This device supports 20 MHz and 40 MHz bandwidth modes.