Exhibits A - D

0320-EX-ST-2000 Text Documents

XM Radio, Inc.

2000-08-03ELS_40443

                                            Exhibit A
                            Experiment Objectives and Operations

      XM Radio Inc. ("XM Radio") intends to utilize a System Validation Single Frequency
Network (SV—SFN) of a fixed location to test the deployment of its terrestrial repeater system.
The terrestrial network will retransmit the satellite Digital Audio Radio Service (DARS) system
signal. Satellite signals at S—Band do not fully provide coverage to urban areas due to the severe
blockage from buildings. Consequently, a terrestrial network will retransmit the satellite service
signal to provide coverage in those urban areas where the satellite signal is blocked. To optimize
the network planning, XM Radio plans to conduct a series of tests in Minneapolis beginning by
August 25, 2000.

        Testing of the SV—SFN transmitter system will be for the purpose of channel
characterization, including signal power and multi—path characteristics, to assist in establishing
and validating propagation and channel models for a single frequency network. These
measurements will help verify techniques and equipment. The test team will have access to the
transmitter so they can monitor and control the equipment.

       Testing is planned for the period of late August through late February 2001. XM Radio
will conduct the tests twenty—four hours per day, seven days per week.


                                                    Exhibit B
                     Transmitter Locations and Transmitter Technical Parameters

          The System Validation Single Frequency Network (SV—SFN) proposed herein will
consist of a fixed transmitter located in Minneapolis, Minnesota. The specific geographic and
site parameters and technical characteristics of the repeater are provided below. The antenna for
the standard transmitter will be located on controlled access rooftops, top floor equipment rooms,
or towers. The antennas will not extend more than 6 meters above the building height.
Information regarding the "Ground Elevation Above Mean Sea Level," "Transmitter Height
Above Ground Level," and "Height Above Average Terrain" is provided below.

Site    Latitude       Longitude    Ground        Transmitter   Height    EIRP    EIRP      Orientation   Beam—
                                    Elevation     Height        Above     (dBm)   (Watts)                 width
                                    AMSL          AGL (ft)      Average                                   (deg.)
                                    (A)                         Terrain
                                                                (f)         *
1       44—58—32 N     93—16—18 W   860           805           887       58.4    692       omni          360

Characteristics of Repeater:


    Component/Parameter                   Value                              Notes

    Transmit Frequency                    2332.5 — 2345 MHz                  Adjustable center frequency
                                                                             within range

    Signal & Modulation                   Continuous Wave/MCM


                                           Exhibit C
                              Radio Frequency Exposure Compliance

          Because the transmitter antenna will be located on controlled access building roof tops,
top floor equipment rooms, or towers, the exposure to humans will be limited. The transmitter
can be turned off when roof top or tower activities close to the antenna are required by
maintenance or other workers. In addition, the antenna will be situated such that the distance to
near—by buildings will be greater than that indicated by the calculations listed below.
Consequently, the FCC radio—frequency field exposure limits will not be exceeded.

       For the purposes of predicting RF field strength and power density levels, the following
equations from the OET Bulletin 65‘ are used:

          S = EIRP
              41 R

where:           S= Power Density (mW/ sq cm)
                 EIRP = Transmit Power (mW) x Antenna Gain (relative it isotropic radiator)
                 R = distance to the center of radiation of the antenna (m)

          As a worst case prediction, 100% reflection of the incoming radiation is assumed. This is
representative of a roof top environment. This results in a four fold increase in power density
giving:

          S= EIRP
             IR

          Based on the FCC limits outlined in OET Bulletin 65 for maximum permissible exposure
(MPE) for a frequency of 2340 MHz, the maximum allowable power density is calculated to be:

          General Population Exposure =                       1.0 mW/ sq cm
          Occupational Exposure =                             5.0 mW/ sq cm




       ‘Evaluating Compliance with FCC Guidelines for Human Exposure to Radiofrequency
Electromagnetic Fields, FCC OET Bulletin 65, Ed. 97—01, August 1997.


        Using these limits, the minimum separation distance required to receive this power
density is calculated as a function of the antenna discrimination and shown in Table 1.

                             Table 1. RF Exposure Limit Ranges
   Angle Below Main Beam            Antenna Gain       Occupational (m)      General Pop (m)
             (Deg)                      (dBi)
               0                          10                  2.52                  5.64
               5                          6                   1.59                  3.56
               10                         —6                  0.40                  0.89
               15                         —2                  0.63                  1.42
               20                         —6                  0.40                  0.89
               25                         —3                  0.56                  1.26
               30                         —8                  0.32                 0.71
               35                         —5                  0.45                  1.00

               40                         —9                  0.28                 0.63

               45                         —5                  0.45                  1.00

               50                        —14                  0.16                 0.36

               55                         —8                  0.32                 0.71

               60                         —9                  0.28                 0.63

               65                        —18                  0.10                 0.22

               70                         —9                  0.28                 0.63

               75                         —8                  0.32                 0.71

               80                         —9                  0.28                 0.63
               85                        —10                  0.25                 0.56
              90                         —13                  0.18                 0.40

This is a worse case RF Exposure calculation.


                                            Exhibit D
                              Emission Isolation to Existing Systems

          XM Radio recognizes that the experimental transmitters are not allowed to cause harmful
interference to nearby stations including systems operating in adjacent bands. In addition, XM
Radio understands that space communications (Deep Space Network (DSN) in the 2290—2300
MHz band) and Radioastronomy (ARECIBO in the 2370—2380 MHz band) as well as
aeronautical telemetry systems (>2360 MHz) operate in nearby bands. As noted in the Wireless
Communications Service Report and Order (FCC 97—112), some existing multipoint distribution
service and instructional television fixed service systems (MDS/ITFS) have a poor front—end
design with limited frequency selectivity and are thus susceptible to out—of—band emissions. XM
Radio analysis, however, indicates that there is a very low probability for causing interference to
existing systems both at the frequency of operation and in adjacent bands.

          Because the experimental transmitters will be located on roof tops or on towers, they may
be situated near base stations for systems such as MDS/ITFS. Preliminary measurements of the
high power amplifier indicate that harmonics will be — 55 dBc and spurious emissions less than
—60dBc. This combined with other reductions to out—of band emissions (e.g., filtering at input to
HPA, coupling loss to antenna) will dramatically reduce any emission outside the 2320 — 2345
MHz band.


Document #: 964439 v.1


                                        Technical Certification

        I, John (Jack) Wormington, Senior Vice President, Engineering and Operations of XM

Radio Inc. ("XM Radio"), hereby certify the following under penalty of perjury:

       I have reviewed the foregoing "Request of XM Radio Inc. for Special Temporary

Authority in the Experimental Radio Service to Conduct Test Operations of S—band Digital

Audio Radio Service Terrestrial Repeaters." The information contained in this application is true

and correct to the best of my belief.




                                                      John (Jack) Wormington


Dated: July 24, 2000



Document Created: 2001-07-26 16:28:50
Document Modified: 2001-07-26 16:28:50

© 2024 FCC.report
This site is not affiliated with or endorsed by the FCC